Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio SP9100DN — Trang 14/18

Code: 828

Description: Self-diagnostic error 7: ROM
Measuring the CRC for the boot monitor and operating system program results in an error. A check of the CRC value for ROMFS of the entire ROM area results in an error.
Causes: • Software defective • Controller board defective • ROM defective

Code: 829

Description: Self-diagnostic Error: Optional RAM
The optional RAM returned an error during the self-diagnostic test.
Causes: • Replace the optional memory board • Controller board defective

Code: 833

Description: Self-diagnostic error 8: Engine I/F ASIC
Causes: 0F30 0F31 ASIC (Mandolin) for system control could not be detected. After the PCI configuration, the device ID for the ASIC could not be checked. • ASCI (Mandolin) for system control is defective • Interface between North Bridge and AGPI is defective • Replace the mother board 0F41 The read/write check done for resident RAM on the mother board could not be done correctly. • Memory device defective • Replace the mother board 50B1 Could not initialize or read the bus connection. • Bus connection defective, loose • SSCG defective • Replace the mother board 50B2 Value of the SSCG register is incorrect. • Bus connection loose, defective • SSCG defective • Replace the mother board

Code: 834

Description: Self-diagnostic error 9: Optional Memory RAM DIMM 5101 The write/verify check for the optional RAM chip on the engine mother board gave an error.
Causes: • Controller defective • Mother board defective

Code: 838

Description: Self-diagnostic Error: Clock Generator A verify error occurred when setting data was read from the clock generator via the I2C bus
Causes: • Replace the controller board

Code: 839

Description: Serial Flash A read/write operation on the Software Status Register failed.
Causes: • Replace the controller board

Code: 850

Description: Net I/F error Duplicate IP addresses. Illegal IP address. Driver unstable and cannot be used on the network
Causes: • IP address setting incorrect • NIB (PHY) board defective • Controller board defective

Code: 857

Description: USB I/F Error
The USB driver is not stable and caused an error.
Causes: • Bad USB card connection • Replace the controller board
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie