Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio SP9100DN — Trang 7/18

Code: 551

Description: Fusing thermistor error 1
The end thermistor (contact type) was less than 0C (32F) for more than 7 seconds.
Causes: • Thermistor disconnected • Thermistor connector defective

Code: 552

Description: Fusing thermistor error 2
The end thermistor (contact type) could not detect: 100°C 25 seconds after the start of the warmup cycle. A change in temperature more than than 16 degrees for 5 seconds. The reload temperature with 56 seconds after the start of the fusing temperature control cycle.
Causes: • Fusing lamp disconnected • Thermistor bent, damaged • Thermistor position incorrect

Code: 553

Description: Fusing thermistor error 3
The end thermistor (contact type) was at 240°C (464°F) for more than 1 second. The temperature is read 10 times every sec. (at 0.1 sec. intervals).
Causes: • PSU defective • IOB control board defective • BICU control board defective`

Code: 555

Description: Fusing lamp error
After the start of the warmup cycle, a fusing lamp was at full power for 1.8 seconds but the hot roller did not turn.
Causes: • Thermistor bent, out of position • Fusing lamp disconnected • Circuit breaker opened

Code: 557

Description: Zero cross signal error
High frequency noise was detected on the power line.
Causes: • No action required. The SC code is logged and the operation of the machine is not affected.

Code: 559

Description: Fusing jam: 3 counts
At the fusing exit sensor the paper was detected late for three pulse counts (lag error), and SP1159 was on.
Causes: • If this SC occurs, the machine cannot be used until the service technician cancels the SC code. • This SC does occurs only if SP1159 has been set to "1" (On). (Default: 0 (Off)).

Code: 569

Description: Fusing pressure release motor error
During copying, the HP sensor could not detect the actuator, tried again 3 times and could not detect.
Causes: • Motor lock because of too much load • Motor driver defective • HP sensor defective, disconnected, connector defective, harness damaged

Code: 590

Description: Toner collection motor error
The toner collection motor sensor output does not change for 3 seconds while the toner collection motor is on.
Causes: • Motor lock due to obstruction • Motor driver board defective • Motor connection loose, defective • Toner collection motor sensor disconnected, sensor defective • Rotational transmission shaft (o6 x 30) missing
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie