Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio SPC430DN — Trang 16/17

Code: 874

Description: Delete All error 1: HDD
An error is detected while all of the HDD or NVRAM are formatted physically by the DataOverwriteSecurity Unit.
Causes: • DataOverwriteSecurity Unit (SD card) not installed • Defective HDD
Remedy: 1. Install the DataOverwriteSecurity Unit. 2. Replace the HDD.

Code: 875

Description: Delete All error 2: Data area
An error is detected while all of the HDD or NVRAM are formatted logically by the DataOverwriteSecurity Unit.
Causes: • The logical format for the HDD fails.
Remedy: Turn the main switch off/on and try the operation again

Code: 876

Description: Log Data Error
An error was detected in the handling of the log data at power on or during machine operation. This can be caused by switching the machine off while it is operating.
Causes: -001 Log Data Error 1 • Damaged log data file in the HDD Initialize the HDD. -002 Log Data Error 2 • An encryption module not installed 1. Disable the log encryption setting with SP9730-004 ("0" is off.) 2. Install the DESS module. -003 Log Data Error 3 • Invalid log encryption key due to defective NVRAM data 1. Initialize the HDD. 2. Disable the log encryption setting with SP9730-004 ("0" is off.) -004 Log Data Error 4 • Unusual log encryption function due to defective NVRAM data Initialize the HDD. -005 Log Data Error 5 • Installed NVRAM or HDD which is used in another machine 1. Reinstall the previous NVRAM or HDD. 2. Initialize the HDD. -099 Log Data Error 99 • Other than the above causes Ask your supervisor.
Remedy:

Code: 877

Description: HDD Data Overwrite Security SD card error
The 'all delete' function cannot be executed but the DataOverwriteSecurity Unit is installed and activated.
Causes: • Defective SD card • SD card not installed
Remedy: 1. Replace the NVRAM and then install the new SD card. 2. Check and reinstall the SD card.

Code: 878

Description: TPM system authentication error
The system firmware is not authenticated by TPM (security chip).
Causes: • Incorrect updating for the system firmware • Defective flash ROM on the controller board
Remedy: Replace the controller board.

Code: 881

Description: Management area error
This is a software error than can occur: • At login • When a print job was received • When WEB browser was opened
Causes: Cycle the machine off/on.
Remedy: Cycle the machine off/on.

Code: 899

Description: Software error
A software error occurred in the GW controller.
Causes: • Cycle the machine off/on • Update controller firmware • Controller board defective
Remedy:

Code: 900

Description: Electric counter error
Abnormal data in the counters.
Causes: • Defective NVRAM • Defective controller
Remedy: 1. Check the connection between the NVRAM and controller. 2. Replace the NVRAM. 3. Replace the controller.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie