Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh B132 Aficio 3260C V-C1 — Trang 19/31

Code: SC547

Description: Zero cross error
When the main switch is turned on, the machine checks how many zero-cross signals are generated within 500 ms. This SC code is issued if the number of zero-cross signals detected is either more than 66 or less than 45 for 10 readings. Note: Zero cross signals, generated from an ac power supply, are used to generate a trigger pulses to control the applied power accurately.
Causes: • Electrical noise on the power supply line • Fusing relay damaged: replace the PSU.

Code: SC548

Description: Heating roller thermistor 2 error 2: Failed to reach warmup temperature
After the main switch is turned on or the cover is closed, the heating roller temperature does not reach the ready temperature within 2 sec. after the heater switches on. -or- If the roller was below 45°C, the heating roller did not reach the ready temperature 2 sec. after reaching 45°C. Note: Thermistor 2 stops monitoring the temperature once Thermistor 1 detects warmup temperature.
Causes: • Thermistor is bent, installed incorrectly • Defective heating roller thermistor • Heating roller fusing lamp broken • Defective BCU

Code: SC549

Description: Heating roller thermistor 2 error 3: Software - High Temperature
The thermistor detected a temperature over 250°C times within 1 sec.
Causes: • TRIAC short • IOB defective • BICU defective • Fusing temperature control is erratic

Code: SC550

Description: Heating roller thermistor 2 error 4: Hardware - High Temperature
The thermistor detected a temperature over 260°C.
Causes: • TRIAC short • IOB defective • BICU defective • Fusing temperature control is erratic

Code: SC551

Description: Pressure roller thermistor error 1
The temperature measured by the pressure roller thermistor does not reach 0°C for 200 sec.
Causes: • Loose connection of the pressure roller thermistor • Defective pressure roller thermistor • Defective BCU

Code: SC552

Description: Pressure roller thermistor error 2
After the main switch is turned on or the cover is closed, the heating roller temperature does not reach the ready temperature within 2 sec. after the heater switches on. -or- If the roller was below 45°C, the heating roller did not reach the ready temperature 2 sec. after reaching 45°C. Note: Thermistor 2 stops monitoring the temperature once Thermistor 1 detects ready temperature.
Causes: • Pressure roller thermistor harness loose, disconnected, defective • Pressure roller thermistor defective

Code: SC553

Description: Pressure roller thermistor error 3: Software -High temperature
The thermistor detected a temperature over 220°C times within 1 sec.
Causes: • TRIAC short • IOB defective • BICU defective • Fusing temperature control is erratic

Code: SC554

Description: Pressure roller thermistor error 4: Hardware - High temperature
The thermistor detected a temperature over 230°C.
Causes: • TRIAC short • IOB defective • BICU defective • Fusing temperature control is erratic
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie