Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh B180 Aficio 3245C JC-2

Code: 101

Description: Exposure lamp error
• The standard white level is not correctly detected when scanning the shading plate. (The shading data peak does not reach the specified threshold)
Causes: • Exposure lamp defective • Lamp stabilizer defective • Exposure lamp connector defective • Standard white plate dirty • Scanner mirror or scanner lens out of position or dirty • SBU defective

Code: 120

Description: Scanner home position error 1
• The scanner home position sensor does not detect the -on“ condition during scanning.
Causes: • Scanner I/O board or SBU defective • Scanner motor defective • Harness between scanner I/O board and scanner motor disconnected • Scanner HP sensor defective • Harness between SBU and HP sensor disconnected • Scanner wire, timing belt, pulley, or carriage defective

Code: 121

Description: Scanner home position error 2
• The scanner home position sensor does not detect the off“ condition during scanning.
Causes: • Scanner I/O board or SBU defective • Scanner motor defective • Harness between scanner I/O board and scanner motor disconnected • Scanner HP sensor defective • Harness between SBU and HP sensor disconnected • Scanner wire, timing belt, pulley, or carriage defective

Code: 141-001

Description: Black level detection error
• The black level cannot be adjusted within the target value during the zero clamp after the home position detection.
Causes: • Defective SBU

Code: 141-002

Description: Black level detection error
• The black level cannot be adjusted within the target value during the zero clamp after the AGC.
Causes: • Defective SBU

Code: 142

Description: White level detection error
• The white level cannot be adjusted within the target during auto gain control.
Causes: • Dirty exposure glass or optics section • SBU board defective • IPU board defective • Exposure lamp defective • Lamp stabilizer defective

Code: 144

Description: SBU communication error
• The SBU hardware is inconsistent with the software.
Causes: • Defective SBU hardware • Incorrect software

Code: 161

Description: IPU error
• After the command is written into the DFID self-diagnosis startup register, the correct value is not stored in the register in the specified duration. NOTE: This error is detected when the main switch is turned on. • After the negate interruption of FGATE occurs, IPU is not recognized in the specified duration. NOTE: This error is detected during scanning operations.
Causes: • IPU board defective (defective connection between ASIC and DFID, or Defective LSYNC)
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie