Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh B188 Aficio 480W Dolphin-C2 — Trang 6/12

Code: SC633

Description: Key/card counter device error 2
During communication with the device, the BCU received a break (Low) signal.
Causes: • The serial line from the device to the copier is unstable, disconnected, or defective.

Code: SC634

Description: Key/card counter device error 3
The backup battery of the counter device RAM is low.
Causes: • Replace the RAM backup battery.

Code: SC635

Description: Key/card counter device error 4
After installation of the device a message alerts user to a battery voltage abnormal error.
Causes: • Device control board defective • Device control board backup battery defective

Code: SC670

Description: Engine startup error
The BCU failed to respond with the prescribed time when the machine was turned on.
Causes: • Connections between BCU and controller board are loose, disconnected, or damaged • Replace the BCU • Replace the controller board

Code: SC672

Description: Controller startup error
• After power on, the line between the controller and the operation panel did not open for normal operation. • After normal startup, communication with the controller stopped.
Causes: • Controller stalled • Controller installed incorrectly • Controller board defective • Operation panel harness disconnected or defective

Code: SC818

Description: Watchdog error
While the system program is running, a bus hold or interrupt program goes into an endless loop, preventing any other programs from executing.
Causes: • System program defective; switch off/on, or change the controller firmware if the problem cannot be solved • Controller board defective • Replace peripheral device

Code: SC819

Description: Fatal kernel error
Due to a control error, a RAM overflow occurred during system processing. One of the following messages was displayed on the operation panel.
Causes: • System program defective • Controller board defective • Optional board defective • Replace controller firmware

Code: SC820

Description: Sellf-diagnostic error 1: CPU
An unexpected error occurred, or the boot monitor program or self-diagnostic program generated an interrupt. In either case, this is a fatal error.
Causes: • Replace the controller board • Update (upload again) all firmware modules to restore the boot program and the self-diagnostics.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie