Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh B234 MP9000 B-C3 — Trang 11/25

Code: SC545

Description: Fusing Overheat Error 3: Continuous Lamp On
After warm-up and while the hot roller is not rotating, the fusing lamps remain on at full power for 45 s (B234/B235) 90 s (B236).
Causes: • Fusing thermistor out of position
• One or more fusing lamp is disconnected

Code: SC547

Description: Zero-Cross Signal Not Detected
The applied bandwidth is detected above 66 Hz or below 45 Hz, and no zero-cross signal detected for 5 s with the power relay ON.
Causes: • Noise on the ac power line
• Cycle the machine off/on
• If the problem continues, install a noise filter

Code: SC557

Description: Zero-Cross Signal Over
Noise was detected on the power supply line.
Causes: • Cycle the machine off/on
• If the problem continues, install a noise filter

Code: SC559

Description: Fusing Unit Jam Error
The paper cooling job time sensor detected paper late for 3 counts. This SC only occurs if SP1159 is on, and a jam occurred in the fusing unit for three consecutive sheets of paper.
Causes: • Remove the paper that is jammed in the fusing unit. Then make sure that the fusing unit is clean and has no obstacles in the paper feed path.

Code: SC585

Description: Double-Feed LED Adjustment Error
The calibration of the double-feed LED for the paper type failed reach the target voltage. The print job completed without the double-feed detection operating. The target voltages are: • Normal paper 3.0V±1% • Translucent paper: 3.8V±2% • OHP: 4.0V±2%
Causes: • Double-feed sensor/LED dirty
• Sensor/LED connector loose, broken, defective

Code: SC592

Description: Toner Bank Motor Error
An abnormal signal was received from the toner bank motor.
Causes: • Toner bank motor defective
• Bank motor connector loose
• Mechanical overload on the drive mechanism

Code: SC593

Description: Toner Suction Motor Replace Alert
The total operation time of the motor exceeded 600 hours. Note: A near-end message appears on the operation panel when the service life of the motor exceeds 570 hours.
Causes: • The toner suction motor has reached the end of its service life.

Code: SC601

Description: Communication Error Between BCU and MCU
One or more of the following occurred:
• The BCU cannot communicate with the MCU within 100 ms after power on after 3 tries.
• A BREAK signal was detected after connection between the BCU and MCU.
• After a communication error, three tries to communicate with the MCU failed.
Causes: • Poor connection between BCU and MCU
• BCU defective
• MCU defective
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie