Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh D062 MP6001 MT-C4 — Trang 11/27

Code: 559

Description: Fusing jam: 3 counts
At the fusing exit sensor the paper was detected late for three pulse counts (lag error), and SP1159 was on.
Causes: • If this SC occurs, the machine cannot be used until the service technician cancels the SC code. • This SC occurs only if SP1159 has been set to "1" (On). (Default: 0 (Off)).
Remedy:

Code: 569

Description: Fusing pressure release motor error
During copying, the HP sensor could not detect the actuator, tried again 3 times and could not detect.
Causes: • Motor lock because of too much load • Motor driver defective • HP sensor defective, disconnected, connector defective, harness damaged
Remedy:

Code: 590

Description: Toner collection motor error
The toner collection motor sensor output does not change for 3 s while the toner collection motor is on.
Causes: • Motor lock due to obstruction • Motor driver board defective • Motor connection loose, defective • Toner collection motor sensor disconnected, sensor defective • Rotational transmission shaft (o6 x 30) missing
Remedy:

Code: 599

Description: 1-bin Exit Motor Error (Japan Only)
The transport lock sensor output does not change within 300 ms after the motor switches on.
Causes: • Motor overload • Motor driver defective
Remedy:

Code: 620

Description: BICU/ADF communication/timeout error
After 1 data frame is sent to the finisher MBX, an ACK signal is not received within 100 ms, and is not received after 3 retries
Causes: • Serial line connection unstable • External noise on the line
Remedy:

Code: 621

Description: BICU/Finisher communication/break error
During communication with the finisher MBX, the BICU received a break (Low) signal from the finisher.
Causes: • Serial line connection unstable • External noise on the line
Remedy:

Code: 623

Description: BICU/Tray 1 to 4 communication/timeout error
After 1 data frame is sent to the trays, an ACK signal is not received within 100 ms, and is not received after 3 retries.
Causes: • Serial line connection unstable • External noise on the line
Remedy:

Code: 625

Description: VBCU-DTMB (DMC1) communication error
Communication between the VBCU and DMC (main) was interrupted. An ACK/NAK signal was not received within 100 ms after a data frame was sent and three retries failed.
Causes: • Check the DTMB harness connections at the DTMB and VBCU • DTMB defective • PSU defective • VBCU defective • 5V power supply defective
Remedy:
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie