Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh D082 MPC7501 V-C3 — Trang 19/44

Code: SC446

Description: ITB lift motor error
The state of the ITB lift sensor does not change its state (switching from off to on or vice versa), even after the ITB lift motor starts rotating.
Causes: • ITB lift sensor dirty, disconnected, defective • ITB lift motor disconnected, defective • ITB sensor defective • ITB lift motor defective

Code: SC447

Description: Image transfer roller position error
The machine checks for the presence of the K STC and the checks the status of the K image transfer roller lift sensor after the door is closed.
Causes: • Transfer belt release lever down • Lift sensor connector loose, broken, dirty • Lift sensor defective

Code: SC450

Description: Transfer power pack output error
An interrupt checks the status of the power pack every 2 ms. This SC is issued if the VBCU detects a short in the power pack 250 times at T2 within 500 ms.
Causes: • Damaged insulation on the high-voltage supply cable • Damaged insulation around the highvoltage power supply. • Check SIOB harness connections • SIOB defective

Code: SC452

Description: PTR lift mechanism error
The PTR was not detected at the home position within 2 sec. after the PTR lift motor turned on.
Causes: • PTR HP sensor dirty, disconnected, defective • PTR lift motor disconnected, defective

Code: SC455

Description: PTR motor error
The lock signal from the paper transfer motor was not detected within 1 sec. after the motor switched on.
Causes: • Motor disconnected • PTR shaft locked, needs cleaning, blocked by obstruction • Drive shaft of the ITB locked and overloaded, needs cleaning, or blocked by obstruction • DRB disconnected, defective

Code: SC460

Description: Separation power pack output error
This SC is issued if the VBCU detects a short in the transfer power pack.
Causes: • Damaged insulation on the high-voltage supply cable (replace cable) • Damaged insulation around the transfer power pack

Code: SC465

Description: Image Transfer Roller End: K
The machine detected an abnormal reading of the resistance of the transfer roller because it is near the end of its service life.
Causes: • Check the connections between the transfer roller power pack the roller • Replace image transfer roller • Image transfer power pack defective

Code: SC466

Description: Image Transfer Roller End: M
The machine detected an abnormal reading of the resistance of the transfer roller because it is near the end of its service life.
Causes: • Check the connections between the transfer roller power pack the roller • Replace image transfer roller • Image transfer power pack defective
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie