Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh D132 MP7502 — Trang 4/33

Code: 221

Description: Laser Synchronization Detector Error: K Leading Edge (Not LD0) While the polygon motor is rotating normally, no synchronizing detection signal is output for black, leading edge for any LD other than LD0.
Causes: • Harness between the laser synchronizing detector and I/F unit is disconnected, defective • Check all connections between LD unit, LDB, IPU • LD unit • LDB defective • IPU defective

Code: 230

Description: FGATE ON error: K The PFGATE ON signal does not assert within 5 seconds after processing the image in normal job or MUSIC for start position [K].
Causes: • Defective ASIC • Poor connection between controller and BICU. • Defective BICU

Code: 231

Description: FGATE OFF error: K • The PFGATE ON signal still asserts within 5 seconds after processing the image in normal job or MUSIC for end position [K]. • The PFGATE ON signal still asserts when the next job starts.
Causes: See SC 230 for troubleshooting details.

Code: 240

Description: LD error: K The BICU detects LDB error a few times consecutively when LDB unit turns on after LDB initialization.
Causes: • Worn-out LD • Disconnected or broken harness of the LD

Code: 270

Description: GAVD communication error A problem occurred in the GAVD or eSOC.
Causes: - Check connection points on the BCU, IPU for loose, broken, or defective harness or connector - IPU defective -BCU defective - LDU effective

Code: 300

Description: Charge corona output error The feedback voltage from the charge corona unit is detected too high 9 times.
Causes: • Charge corona power pack defective • Charge corona harness disconnected • Poor charge corona unit connection

Code: 305-00

Description: Charge corona wire cleaner error 1 The charge cleaner pad does not arrive at the home position: Motor locked within 4 s after switching on, or does not lock within 30 s. Motor locked within 10 s after reversing, or does not lock within 30 s.
Causes: • Charge corona wire cleaner motor defective • Motor driver defective

Code: 306-00

Description: Charge corona wire cleaner error 2 Charge corona motor is disconnected. (The current at the charge corona motor is detected less than 83 mA.)
Causes: • Charge corona wire cleaner motor connector is defective or disconnected.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie