Description: Serial Number Mismatch Serial number stored in the memory does not have the correct code.
Causes: • NVRAM defective • BCU replaced without original NVRAM
Remedy: 1. Reinstall the original NVRAM in the replaced BCU. 2. Turn off and on the main power switch of the copier if a new NVRAM is installed in the BCU.
Description: Polygon motor error 1: ON timeout The polygon mirror motor did not reach the targeted operating speed within 10 sec. after turning on or changing speed
Description: Laser synchronization detection error 1: LD0 The laser synchronizing detection signal for the start position of the LD was not output for 500 ms after LDB unit turned on with the polygon motor rotating normally.
Description: Laser synchronization detection error 2: Other than LD0 The laser synchronizing detection signal for the start position of the LD other than LD0 was not output for 500 ms after LDB unit turned on with the polygon motor rotating normally.