• Code: E 17
• Description: Replace Battery
  Displayed to interrupt the machine operation:
  1) If the Battery detection signal is OFF at either of following three cases. <1> when the machine power is turned ON <2> when All reset button is pressed <3> at the end of machine operation.

• Code: E 18
• Description: Sorter Error
  Displayed to interrupt the machine operation:
  1) If an error signal is received from the sorter.

• Code: E 19
• Description: Thermal Pressure Motor Lock
  Displayed to interrupt the machine operation:
  1) If the TPH Pressure switch has not been depressed within 4 seconds after the TPH Pressure motor was activated to lower the TPH.
  2) If the TPH Pressure switch has not been released within 4 seconds after the TPH Pressure motor was activated to raise the TPH.

• Code: E 20
• Description: Wing Motor Lock
  Displayed to interrupt the machine operation:
  1) If neither of the Jump wing sw1 or sw2 has been depressed within 5 seconds after the Wing motor was activated.
  2) If neither of the Jump wing sw1 or sw2 has been released within 5 seconds after the Wing motor was activated.

• Code: E 21
• Description: Master Loading Error (onto the Drum)
  Displayed to interrupt the machine operation:
  1) If the Master load sensor does not detect master at the Drum C-1 position during loading of the master on the Drum.

• Code: E 22
• Description: Master Mis-Feed
  Displayed after the master has been loaded onto the Drum in the master making or confidential process:
  1) If the Master positioning sensor has not detected master material within 787 pulses (536 pulses in confidential process) after the Loading pulse motor started following the master cutting operation. Displayed to interrupt the machine operation when the Master loading button was pressed: 1) If the Master positioning sensor has not detected master material within 1260 pulses after the Loading pulse motor was turned on.
  2) If the Master positioning sensor has not detected master material within 787 pulses after the Loading pulse motor was turned on following the operation of the Cutter motor and the cut master material is removed.

• Code: E 23
• Description: Master Cut Malfunction
  Displayed to interrupt the machine operation in master-making and confidential process:
  1) If master is detected by the Master positioning sensor at Drum A position after the cutting operation and besides it is not detected by the Master positioning sensor at the next Drum A position detection after the second cutting operation.

• Code: E 24
• Description: A Cut Piece of Master Remains inside the Machine Displayed:
  1) If the Master positioning sensor detects master material (the reflected light) just after the master cut operation is completed.