Code :

Code: EE EL
Description: Auto developing tone adjustment trouble (overtoner error). A sample data is less than 0 when auto developing adjustment is executed.
Causes: Toner density sensor defective Charging voltage or developing voltage improper. Toner density improper Developing unit defective PCU PWB defective
Remedy: Make auto developing adjustment with SIM25-2.

Code: EE EU
Description: Auto developing adjustment trouble (undertoner error). A sample data is less than 99 when auto developing adjustment is executed.
Causes: Toner density sensor defective Charging voltage or developing voltage improper Toner density improper Unit defective PCU PWB defective
Remedy: Make auto developing adjustment with SIM25-2.

Code: F1 00
Description: Sorter communication trouble. Communication line test error occurs when power is turned on or after the exit of a simulation mode. Improper communication with sorter
Causes: Improper connection or broken wire of connector or harness between copier and sorter Sorter control PWB defective Control PWB (PCU) defective Malfunction due to noise
Remedy: Clear by turning the power supply OFF/ON. Check communication line connector and harness. Replace sorter control PWB or PCU PWB.

Code: F1 03
Description: Sorter guide bar rocking motor drive error
Causes: Motor lock Motor speed error Overcurrent to motor Sorter control PWB defective
Remedy: Check guide bar motor operation with SIM3-10.

Code: F1 04
Description: Sorter indexer lower limit detected. Indexer has exceeded lower limit.
Causes: Sensor defective Sorter control PWB defective
Remedy: Check sensor with SIM3-2.

Code: F1 05
Description: Sorter indexer upper limit detected. Indexer has exceeded upper limit
Causes: Sensor defective Sorter control PWB defective
Remedy: Check sensor with SIM3-2.

Code: F1 06
Description: Sorter bin shift motor error. 1) Bin shift is not completed within 2.5 seconds after bin shift request
Causes: Motor lock Improper motor speed Overcurrent to motor Sorter control PWB defective
Remedy: Check bin shift motor operation with SIM3-4.

< 1 2 3 4 5 > Last ›