Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Sharp ARM277 — Trang 4/10

Code: F1-08

Description: Staple motor error
The staple motor cannot return to the home position.
Causes: Staple motor abnormality Staple motor home position sensor abnormality Staple unit abnormality Finisher PWB abnormality
Remedy: Use SIM 3-3-7 to check the staple motor operation.

Code: F1-11

Description: Rear edge plate home position error
The rear edge plate cannot return to the home position.
Causes: Rear edge plate drive motor abnormality Side guide plate home position sensor abnormality Finisher PWB abnormality
Remedy: Use SIM 3-3-2 to check the rear edge plate motor operation.

Code: F1-15

Description: Finisher lift-up motor trouble
The finisher lift-up motor does not reach the specified position.
Causes: Lift-up motor abnormality Lift-up motor upper limit sensor abnormality Finisher PWB abnormality
Remedy: Use SIM 3-3-5 to check the lift-up motor operation.

Code: F2-02

Description: Toner supply failure
The value judged from the actual toner supply hysteresis differs greatly from the toner sensor value.
Causes: Developing unit trouble Toner supply abnormality caused by installation of unpacked toner cartridge
Remedy: Replace the developing unit Use SIM 25-1 to perform DV stirring.

Code: F2-04

Description: Identification error
Identification error When the CRUM trademark differs. When the CRUM company code differs.
Causes: CRUM chip failure Erroneous developing unit
Remedy: Replace the CRUM chip. Replace the developing unit

Code: F5-02

Description: Copy lamp lighting abnormality
The copy lamp does not light up.
Causes: Copy lamp error Copy lamp harness abnormality CCD PWB harness abnormality
Remedy: Check the copy lamp (SIM 5-3) When the lamp lights: Check the harnesses and connectors between the CCD unit and the MCU PWB. When the lamp does not light: Check the harness and connector between the copy lamp and the MCU PWB. Replace the copy lamp unit. Replace the MCU PWB. Remarks Copy lamp disconnection Cable is not attached.

Code: F6-00

Description: MCU-FAX communication trouble
Communication establishment error/ framing/parity/protocol error
Causes: FAX control PWB connector disconnection Defective harness between FAX control PWB and MCU PWB Motherboard connector pin breakage FAX control PWB ROM error/Data error
Remedy: Check connector/harness of FAX control PWB and MCU PWB. Check the grounding of the copier. Check FAX control PWB ROM.

Code: F6-10

Description: FAX control PWB trouble
Communication trouble between MCU and FAX control PWB
Causes: FAX control PWB connector disconnection Defective harness between FAX control PWB and MCU PWB Motherboard connector pin breakage FAX control PWB ROM error/Data error IC on FAX PWB causes abnormality
Remedy: Check connector/harness of FAX control PWB and MCU PWB. Check the grounding of the copier. Check FAX control PWB ROM. Replace the FAX PWB.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie