Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Toshiba e-Studio 450S — Trang 22/24

Code: 949.00

Description: Delay line calibration failure
Causes: System board
Remedy: Replace the system board.

Code: 950.00

Description: NVRAM mismatch
Causes: EPROM mismatch failure
Remedy: This error code indicates a mismatch between the System Board assembly and the interface card assembly. Warning: In the event of replacement of any one of the following components: • Flatbed interconnect card • System board assembly • Interface card assembly Only replace one component at a time. Replace the required component, and perform a POR before replacing a second component listed above. If this procedure is not followed, the printer will be rendered inoperable. Never replace two or more of the components listed above without a POR after installing each one, or the printer will be rendered inoperable. Warning: Never install and remove components listed above as a method of troubleshooting components. Once a component has been installed in a machine, it cannot be used in another machine. It must be returned to the manufacturer.

Code: 951.00

Description:
Causes:
Remedy: Replace the system board. Warning: When replacing any one of the following components: • Flatbed interconnect card • System board assembly • Interface card assembly Only replace one component at a time. Replace the required component, and perform a POR before replacing a second component listed above. If this procedure is not followed, the printer will be rendered inoperable. Never replace two or more of the components listed above without a POR after installing each one, or the printer will be rendered inoperable. Warning: Never install and remove components listed above as a method of troubleshooting components. Once a component has been installed in a printer, it cannot be used in another printer. It must be returned to the manufacturer.

Code: 952.00

Description: NV failure:n
Causes: CRC error has occurred. This is recoverable.
Remedy: Perform POR to clear the error.

Code: 953.00

Description:
Causes:
Remedy: Replace the operator panel right cover assembly.

Code: 954.00

Description:
Causes:
Remedy: Replace the interface card. Warning: When replacing any one of the following components: • Flatbed interconnect card • System board assembly • Interface card assembly Only replace one component at a time. Replace the required component, and perform a POR before replacing a second component listed above. If this procedure is not followed, the printer will be rendered inoperable. Never replace two or more of the components listed above without a POR after installing each one, or the printer will be rendered inoperable. Warning: Never install and remove components listed above as a method of troubleshooting components. Once a component has been installed in a printer, it cannot be used in another printer. It must be returned to the manufacturer.

Code: 955.00

Description: Code CRC
Causes: CRC failure or ECC code failure on the system board.
Remedy: Replace the system board.

Code: 956.00

Description: System board
Causes: This error indicates a system board processor failure.
Remedy: Replace the system board.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie