Code :

Code: 25
Display:
Description: A label format was sent to the printer. Several labels print, then the printer skips, misplaces, misses, or distorts the image on the label.
Causes: The serial communication settings are incorrect.

Code: 26
Display:
Description: A label format was sent to the printer but was not recognized. The DATA light flashes but no printing occurs.
Causes: The prefix and delimiter characters set in the printer do not match the ones in the label format. Incorrect data is being sent to the printer.

Code: 28
Display:
Description: The printer does not detect when the ribbon runs out. In thermal transfer mode, the printer did not detect the ribbon even though it is loaded correctly.
Causes: The ribbon-out threshold is set too high to detect the ribbon. On a sensor profile, the ribbon-out threshold (circled in Figure 15) appears above the black bars that indicate the ribbon. This happens if you calibrate the printer without ribbon and later insert ribbon without recalibrating the printer or loading printer defaults.

Code: 30
Display:
Description: The LCD displays a language that I cannot read
Causes: The language parameter was changed through the control panel or a firmware command.

Code: 32
Display:
Description: Changes in parameter settings did not take effect
Causes: Parameters are set incorrectly. A command turned off the ability to change the parameter. A command changed the parameter back to the previous setting. If the problem continues, there may be a problem with the main logic board.

< 1 2 3 4 5 >