Code :

Code: E805-0003
Description: Fan failure
Causes: Controller fan failure detected The controller fan does not rotate because some kind of failure occurred in it.
Remedy: Replace the controller fan.

Code: E805-0006
Description: Fan failure
Causes: Power supply fan failure The fan did not rotate even when 12 seconds elapsed after the motor rotation start order was received.
Remedy: Reconnect the connector J21 on the DC controller PCB and the connector J106 on the low-voltage power supply unit. If the voltage between the connectors J21-2 and J25-2 on the DC controller PCB is changed from 0V to approximately 24V immediately after the printer is turned on, replace the power supply fan.

Code: E825-0000
Description: Drum phase control sensor failure warning
Causes: Yellow drum phase control sensor failure warning A slit was not detected for 4 seconds after slit detection started. An abnormal slit width was detected.
Remedy: Check the YMC drum drive gear. Replace the YMC drum HP sensor (PS13).

Code: E825-0001
Description: Drum phase control sensor failure warning
Causes: Magenta drum phase control sensor failure warning A slit was not detected for 4 seconds after slit detection started. An abnormal slit width was detected.
Remedy: Check the YMC drum drive gear. Replace the YMC drum HP sensor (PS13).

Code: E825-0002
Description: Drum phase control sensor failure warning
Causes: Cyan drum phase control sensor failure warning A slit was not detected for 4 seconds after slit detection started. An abnormal slit width was detected
Remedy: Check the YMC drum drive gear. Replace the YMC drum HP sensor (PS13).

‹ First < 5 6 7 8 9 >