• Code: E000
• Description: Startup failure
• Remedy: (1) Check the connectors of the Fixing Assembly. (J101, J1011, J552 and J702)
  (2) Replace the Fixing Assembly.
  (3) Replace the Engine Controller PCB.

• Code: E001
• Description: Abnormal high temperature
• Remedy: (1) Check the connectors of the Fixing Assembly. (J101, J1011, J552 and J702)
  (2) Replace the Fixing Assembly.
  (3) Replace the Engine Controller PCB.

• Code: E003
• Description: Abnormal low temperature
• Remedy: (1) Check the connectors of the Fixing Assembly. (J101, J1011, J552 and J702)
  (2) Replace the Fixing Assembly.
  (3) Replace the Engine Controller PCB.

• Code: E004
• Description: Fixing heater drive circuit error (200V models only)
• Remedy:

• Code: E100
• Description: Scanner area failure
• Remedy: (1) Check the connectors of the Fixing Assembly. (J101, J1011, J552 and J702)
  (2) Replace the Fixing Assembly.
  (3) Replace the Engine Controller PCB.

• Code: E196
• Description: ROM read/write error (error in storing setting values in user mode/service mode/ factory mode)
• Remedy: When the same error repeatedly occurs although the power is turned OFF and then ON for several times, execute the following remedies.
  (1) Update the firmware of the Main Controller PCB.
  (2) Replace the Main Controller PCB.

• Code: E202
• Description: CIS Unit home position detection error / homeward reading position error
• Remedy: When the same error repeatedly occurs although the power is turned OFF and then ON for several times, execute the following remedies.
  (1) Check the connection between the Main Controller PCB and the CIS Unit. (J2)
  (2) Replace CIS Unit.
  (3) Check the connection between the Main Controller PCB and the Reader Motor (M3). (J11)
  (4) Replace the Reader Motor (M3).
  (5) Replace the Main Controller PCB.

• Code: E225
• Description: Insufficient lamp light intensity (The light intensity is at the reference level or below.)
• Remedy: When the same error repeatedly occurs although the power is turned OFF and then ON for several times, execute the following remedies.
  (1) Check the connection between the Main Controller PCB and the CIS Unit. (J2)
  (2) Replace CIS Unit.
  (3) Replace the Main Controller PCB.