• Code: C1500
• Description: CCNV hardware error
• Causes: • Controller (C495MAIN)
• Remedy: 1 After powering the printer OFF, then ON again, check whether the same error status will occur or not. (Repeatability check) 2 Replace the Controller (C495MAIN).

• Code: C1550
• Description: Compression SRAM initialization hardware error
• Causes:
• Remedy:

• Code: C1600
• Description: Video related hardware error (including PWM IC calibration error)
• Causes: • Controller (C495MAIN)
• Remedy: 1 After powering the printer OFF, then ON again, check whether the same error status will occur or not. (Repeatability check) 2 Replace the Controller (C495MAIN).

• Code: C1800
• Description: SPD error of DIMM
• Causes:
• Remedy:

• Code: C1999, C2000
• Description: C1999 Other hardware error C2000 Software error
• Causes: • Controller (C495MAIN)
• Remedy: 1 After powering the printer OFF, then ON again, check whether the same error status will occur or not. (Repeatability check) 2 Replace the Controller (C495MAIN).

• Code: E010
• Description: Process Motor YMC error • When the printer is not put in a ready status if the predetermined time has elapsed at motor-on. • When the printer is put out of the ready status continuously for the predetermined time during motor rotation.
• Causes: • PU Drive Motor Y/M/C (M4) • PU Drive Motor Bk (M5) • Control Board (PWB-A)
• Remedy: 1 Check the motor connector connection status, and correct if it is improper. 2 Check the motor drive coupling status, and correct if it is improper. 3 Check the operation of M4. p115 PWB-A CNPM-A-5A(REM) 9-C 4 Replace the PWB-A.

• Code: E017
• Description: Process Motor K error • When the printer is not put in a ready status if the predetermined time has elapsed at motor-on. • When the printer is put out of the ready status continuously for the predetermined time during motor rotation.
• Causes: • PU Drive Motor Y/M/C (M4) • PU Drive Motor Bk (M5) • Control Board (PWB-A)
• Remedy: 1 Check the motor connector connection status, and correct if it is improper. 2 Check the motor drive coupling status, and correct if it is improper. 3 Check the operation of M5. p115 PWB-A CNPM-A-5B(REM) 12-H 4 Replace the PWB-A.

• Code: E040
• Description: Suction Fan Motor error When the lock signal is detected continuously for the predetermined time during fan rotation.
• Causes: • Fuser Fan Motor (M7) • PH Fan Motor (M8) • Suction Fan Motor (M13) • Ozone Fan Motor (M9) • PS Fan Motor (M6) • PU Fan Motor (M12)
• Remedy: 1 Check the motor connector connection status, and correct if it is improper. 2 Check the load status of the fan section, and correct if it is improper. 3 Check the operation of M13. p115 PWB-A CNF1-A-10(REM) 12-A 4 Replace the PWB-A.