Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Epson Stylus Pro 4400 — Trang 4/8

Code: 00010026

Description: RTC communication error
There may be a case where the RTC circuit on the Main Board operates incorrectly (is operated as test mode). In such a case, this message is displayed and the printer stops operating.
Causes:
Remedy: 1. Remove the battery once with the power turned off and after waiting for a while, install the battery again and turn the power on. 2. Repeat Step1 above until this error does not occur at power-on. • Start up the printer in Maintenance Mode 2 , execute "RTC&USBID&IEEE1394ID" to set the date using basic adjustment in the the adjustment program.

Code: 00010028

Description: Head error
Print Head has been damaged or undefined NMI was detected at CPU.
Causes:
Remedy: Replace the Printhead

Code: 00010029

Description: Unidentified NMI
CPU has detected undefined NMI.
Causes:
Remedy: If this error is not cleared even when the power is turned off once and on again, replace the C593 MAIN Board

Code: 0001002A

Description: CR ASIC ECU error
Causes: • Faulty firmware (irregular overwriting of register, etc.) • Damaged drive circuit board (break in pattern, etc.)
Remedy: 1. Installing Firmware 2. Replace the C593 MAIN Board

Code: 0001002B

Description: PF ASIC ECU error
Causes: • Faulty firmware (irregular overwriting of register, etc.) • Damaged drive circuit board (break in pattern, etc.)
Remedy: 1. Installing Firmware 2. Replace the C593 MAIN Board

Code: 0001002D

Description: Cleaning Unit work life error
Causes: Pump counter (8P x 1000 = 8,000P) has reached its regulated value.
Remedy: Replace the Cleaning Unit and reset the Cleaning Unit work life counter. (Reset When Cleaning Unit Change .) NOTE: Refer to Table 3-4 "Corrective Actions for Displayed Warnings " about the Cleaning Unit components.

Code: 0001002F

Description: 360 DPI writing time out error
At ASIC reset, cannot restore position held before reset or carriage interference, etc.
Causes:
Remedy: Recover by turning power OFF and back ON.

Code: 00010030

Description: Multi Sensor failure
Causes: Multi Sensor is damaged
Remedy: 1. Check if the connection between the Multi Sensor and C593 MAIN Board, and correct it if abnormal. 2. Replace the Multi Sensor
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie