• Code: 00010031
• Description: ASF phase detection error
• Causes: • ASF home position cannot be detected even though Pump Motor turns at designated amount. • ASF Phase Sensor is damaged. • Power supply fuse for ASF/Pump Motor driver is broken on the MAIN Board.
• Remedy: 1. Check if the ASF phase detection wheel rotates smoothly, and correct it if abnormal. 2. Replace the ASF Phase Sensor 3. Replace the C593 MAIN Board

• Code: 00010032
• Description: ASF drive switch error
• Causes:
• Remedy:

• Code: 00010033
• Description: Eject phase detection error
• Causes: Home position for paper eject switching cannot be detected even though PG Motor turns at designated amount, or Paper eject phase sensor is damaged.Or power supply fuse for PG/PO Motor driver is broken on the MAIN Board.
• Remedy: 1. Check if the Paper Eject Unit rotates correctly and correct it if abnormal. 2. Replace the Paper Eject Phase Sensor 3. Replace the C593 MAIN Board

• Code: 00010034
• Description: Eject movement error
• Causes: Floating of paper eject roller due to paper jam or foreign object.
• Remedy: Recover by turning power OFF and back ON after removing paper or foreign object.

• Code: 00010035
• Description: Pump phase detection error
• Causes: Pump position cannot be detected even though Pump Motor turns at designated amount, or Pump Phase Sensor is damaged.Or power supply fuse for ASF/Pump Motor driver is broken on the MAIN Board.
• Remedy: Check whether or not recovery can be done by turning power OFF and back ON. If error recurs, replace the Pump Phase Sensor .Or replace the C593 MAIN Board .

• Code: 00010036
• Description: Type-B board installation error
• Causes: Type-B Board lower than Level 2 is installed.
• Remedy: Remove installed Type-B Board.

• Code: 00010037
• Description: Head thermistor error
• Causes: • The head thermistor is failing. • Thermistor temperature is at -20°C or less or at 100°C or more. • The Head FFC is disconnected or has poor contact.
• Remedy: 1. Check if the "Harness, Head" is connected correctly, and correct it if abnormal. 2. Replace the Printhead

• Code: 00010038
• Description: Transistor thermistor error
• Causes: • The transistor thermistor* is failing. • Thermistor temperature is at -20°C or less or at 100°C or more.
• Remedy: Replace the C593 MAIN Board Note * : A temperature detection part that is attached to the heatsink (address numbers: Q12, Q13, Q14, Q15), which controls ON/OFF status of the head driving voltage, with screws. This part is located at the address “TH1“ on the Main Board.