• Code: 00010039
• Description: PG adjustment value incorrect overwrite error
  Writing to the PG adjustment value area of NVRAM was done improperly, or an improper value was read.
• Causes: • Defective circuit board • Faulty CPU soldering • Program trouble.
• Remedy: 1. Installing Firmware 2. Replace the C593 MAIN Board

• Code: 0001003A
• Description: PG adjustment value outside range error
  A value outside the correction range was written to the PG adjustment value area of NVRAM, or an improper value was read.
• Causes: • Defective circuit board • Faulty CPU soldering • Program trouble • An unsuitable F/W is installed
• Remedy: 1. Installing Firmware 2. Replace the C593 MAIN Board

• Code: 0001003B
• Description: Cutter installation error 1
• Causes: CR lock cannot be released by PG2.6 after cutter replacement. The cutter or cutter pusher is not properly set.
• Remedy: 1. Turn off the printer power. 2. Check the cutter installation condition and correct it if abnormal.

• Code: 0001003C
• Description: Cutter installation error 2
• Causes: CR lock cannot be released by PG1.2 even after 3 attempts with the cutter replacement problem detection movement. The cutter or cutter pusher is not properly set.
• Remedy: 1. Turn off the printer power. 2. Check the cutter installation condition and correct it if abnormal.

• Code: 0001003D
• Description: Cutter installation error 3
• Causes: CR lock cannot be released by PG1.2 the next time the power is turned on if power was turned off during cutter replacement. The cutter or cutter pusher is not properly set.
• Remedy: 1. Turn off the printer power. 2. Check the cutter installation condition and correct it if abnormal.

• Code: 00020000
• Description: NVRAM error
  There may be a case where the parameter data in NVRAM is broken. In such a case, this message is displayed and the printer stops operating.
• Causes: • NVRAM erase error • Write error (Check in 2 bytes)
• Remedy: Replace the C593 MAIN Board

• Code: 00020002
• Description: SDRAM error
  In memory check of SDRAM executed at power on, there may be a case where a bit error is detected. In such a case, this message is displayed and the printer stops operating.
• Causes: SDRAM Read/Write error
• Remedy: Replace the C593 MAIN Board

• Code: 00020003
• Description: BOOT program SUM error
  There may be a case where the boot program of firmware is broken. In such a case, this message is displayed and the printer stops operating. (Only at power on)
• Causes: • Faulty installation • Defective flash memory
• Remedy: 1. Installing Firmware 2. Replace the C593 MAIN Board