Description: RTC communication error
There may be a case where the RTC circuit on the Main Board operates incorrectly (is operated as test mode). In such a case, this message is displayed and the printer stops operating.
Causes:
Remedy: 1. Remove the battery once with the power turned off and after waiting for a while, install the battery again and turn the power on. 2. Repeat Step1 above until this error does not occur at power-on. • Start up the printer in Maintenance Mode 2 , execute "RTC&USBID&IEEE1394ID" to set the date using basic adjustment in the the adjustment program.
Causes: Pump counter (8P x 1000 = 8,000P) has reached its regulated value.
Remedy: Replace the Cleaning Unit and reset the Cleaning Unit work life counter. (Reset When Cleaning Unit Change .) NOTE: Refer to Table 3-4 "Corrective Actions for Displayed Warnings " about the Cleaning Unit components.