Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Epson Stylus Pro 4800 — Trang 6/8

Code: 00010039

Description: PG adjustment value incorrect overwrite error
Writing to the PG adjustment value area of NVRAM was done improperly, or an improper value was read.
Causes: • Defective circuit board • Faulty CPU soldering • Program trouble.
Remedy: 1. Installing Firmware 2. Replace the C593 MAIN Board

Code: 0001003A

Description: PG adjustment value outside range error
A value outside the correction range was written to the PG adjustment value area of NVRAM, or an improper value was read.
Causes: • Defective circuit board • Faulty CPU soldering • Program trouble • An unsuitable F/W is installed
Remedy: 1. Installing Firmware 2. Replace the C593 MAIN Board

Code: 0001003B

Description: Cutter installation error 1
Causes: CR lock cannot be released by PG2.6 after cutter replacement. The cutter or cutter pusher is not properly set.
Remedy: 1. Turn off the printer power. 2. Check the cutter installation condition and correct it if abnormal.

Code: 0001003C

Description: Cutter installation error 2
Causes: CR lock cannot be released by PG1.2 even after 3 attempts with the cutter replacement problem detection movement. The cutter or cutter pusher is not properly set.
Remedy: 1. Turn off the printer power. 2. Check the cutter installation condition and correct it if abnormal.

Code: 0001003D

Description: Cutter installation error 3
Causes: CR lock cannot be released by PG1.2 the next time the power is turned on if power was turned off during cutter replacement. The cutter or cutter pusher is not properly set.
Remedy: 1. Turn off the printer power. 2. Check the cutter installation condition and correct it if abnormal.

Code: 00020000

Description: NVRAM error
There may be a case where the parameter data in NVRAM is broken. In such a case, this message is displayed and the printer stops operating.
Causes: • NVRAM erase error • Write error (Check in 2 bytes)
Remedy: Replace the C593 MAIN Board

Code: 00020002

Description: SDRAM error
In memory check of SDRAM executed at power on, there may be a case where a bit error is detected. In such a case, this message is displayed and the printer stops operating.
Causes: SDRAM Read/Write error
Remedy: Replace the C593 MAIN Board

Code: 00020003

Description: BOOT program SUM error
There may be a case where the boot program of firmware is broken. In such a case, this message is displayed and the printer stops operating. (Only at power on)
Causes: • Faulty installation • Defective flash memory
Remedy: 1. Installing Firmware 2. Replace the C593 MAIN Board
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie