Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Epson Stylus Pro 4800 — Trang 5/8

Code: 00010031

Description: ASF phase detection error
Causes: • ASF home position cannot be detected even though Pump Motor turns at designated amount. • ASF Phase Sensor is damaged. • Power supply fuse for ASF/Pump Motor driver is broken on the MAIN Board.
Remedy: 1. Check if the ASF phase detection wheel rotates smoothly, and correct it if abnormal. 2. Replace the ASF Phase Sensor 3. Replace the C593 MAIN Board

Code: 00010032

Description: ASF drive switch error
Causes:
Remedy:

Code: 00010033

Description: Eject phase detection error
Causes: Home position for paper eject switching cannot be detected even though PG Motor turns at designated amount, or Paper eject phase sensor is damaged.Or power supply fuse for PG/PO Motor driver is broken on the MAIN Board.
Remedy: 1. Check if the Paper Eject Unit rotates correctly and correct it if abnormal. 2. Replace the Paper Eject Phase Sensor 3. Replace the C593 MAIN Board

Code: 00010034

Description: Eject movement error
Causes: Floating of paper eject roller due to paper jam or foreign object.
Remedy: Recover by turning power OFF and back ON after removing paper or foreign object.

Code: 00010035

Description: Pump phase detection error
Causes: Pump position cannot be detected even though Pump Motor turns at designated amount, or Pump Phase Sensor is damaged.Or power supply fuse for ASF/Pump Motor driver is broken on the MAIN Board.
Remedy: Check whether or not recovery can be done by turning power OFF and back ON. If error recurs, replace the Pump Phase Sensor .Or replace the C593 MAIN Board .

Code: 00010036

Description: Type-B board installation error
Causes: Type-B Board lower than Level 2 is installed.
Remedy: Remove installed Type-B Board.

Code: 00010037

Description: Head thermistor error
Causes: • The head thermistor is failing. • Thermistor temperature is at -20°C or less or at 100°C or more. • The Head FFC is disconnected or has poor contact.
Remedy: 1. Check if the "Harness, Head" is connected correctly, and correct it if abnormal. 2. Replace the Printhead

Code: 00010038

Description: Transistor thermistor error
Causes: • The transistor thermistor* is failing. • Thermistor temperature is at -20°C or less or at 100°C or more.
Remedy: Replace the C593 MAIN Board Note * : A temperature detection part that is attached to the heatsink (address numbers: Q12, Q13, Q14, Q15), which controls ON/OFF status of the head driving voltage, with screws. This part is located at the address “TH1“ on the Main Board.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie