Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi HP DesignJet 8000s — Trang 5/5

Code: 1330

Description: Scan-Axis Motor Temperature Sensor Error
The Scan-Axis Motor Temperature Sensor has detected abnormal temperatures (-22.5C or lower or 150C or higher).
Remedy: • Make sure that the Scan-Axis Motor Temperature Sensor is connected correctly and the cable is not damaged. • Replace the Scan-Axis Motor Cooling Fan. • Replace the Main PCA.

Code: 140x

Description: Heater Temperature Error
Temperature read by the Heater Temperature Sensor is abnormal (lower than -20C or higher than 200C). x = 1: Front heater. x = 2: Center Platen. x = 3: Rear Heater.
Remedy: • Make sure that the failing Heater is connected correctly to the Main PCA. Make sure that the cables are not damaged. • Replace the failing Heater. • Replace the Main PCA.

Code: 141x

Description: Heater Error (High Temperature)
Temperature read by the Heater Temperature Sensor is above 65C). x = 1: Front heater. x = 2: Center Platen. x = 3: Rear Heater.
Remedy: • If the Printer is installed in a high temperature environment, move the Printer to an area where the operating temperature is much lower. • Make sure that the failing Heater is connected correctly to the Main PCA. Make sure that the cables are not damaged. • Replace the failing Heater. • Replace the Main PCA.

Code: 143x

Description: Heater Error (Insufficient Heating)
The Heater is not heated to a specified temperature even after 30 minutes have passed. x = 1: Front heater. x = 2: Center Platen. x = 3: Rear Heater.
Remedy: • If the Printer is installed in a low temperature environment, move the Printer to an area where the operating temperature is much higher. • Check that the AC Voltage being used is the one selected on the Heater Voltage Setting Switch. • Make sure that the failing Heater is connected correctly to the Main PCA. Make sure that the cables are not damaged. • Replace the Heater Relay Board. • Replace the failing Heater. • Replace the Main PCA.

Code: 144x

Description: Heater Error
No heater sequence interrupt.
Remedy: • Make sure that all the cables are correctly connected to the Heater Relay Board. Make sure that the cables are not damaged. • Replace the Heater Relay Board. • Replace the Main PCA.

Code: 2000 ... 6000

Description: Firmware Logic Error
A logic error has occurred in the Firmware program.
Remedy: • Reinstall the Firmware or upgrade to the latest version (if available). • Replace the Main PCA.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie