• Code: 06.03
• Description: NVM file has a bad CRC. NVM file has a bad CRC.
• Remedy: • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • If the System Error continues, replace the Hard Disk Drive .

• Code: 06:10
• Description: Main NVM failure. Main NVM failure - not detected, read/write failed or readback error.
• Remedy: • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • If the System Error continues, replace the Hard Disk Drive .

• Code: 08:11
• Description: Connection problem with the Front Panel. Problem with communication between the Front Panel, the Formatter and the HDD.
• Remedy: • Switch the Power OFF from the back of the Printer and disconnect the Power cord. Reconnect the power cord and power On the Printer. • If the printer emits one or multiple fbeepsf as the printer turns On, perform the procedure fUsing the buzzer at Power-up to Troubleshootf ËPage 43. Four beeps would indicate an error with the Front Panel: • Check that the Front Panel cable is not damaged and is correctly connected to the Front Panel and to the Interconnect PCA. • Check that the Memory Module is installed correctly. • Check that the cables between the Interconnect PCA and the Main PCA are not damaged and are correctly connected. • Check that the cables between the Hard Disk Drive and the Power Supply Unit and the Main PCA are not damaged and are correctly connected. • Check that the cable between the Power Supply Unit and the Main PCA is not damaged and is correctly connected. • Check that the Printer has the latest Firmware version, if not, update the firmware to the latest version. • Replace the Interconnect PCA . • Replace the Sausalito PCI PCA .

• Code: 09.01:10
• Description: TOMAS Error. There is an error with the TOMAS reading. The measurements are unstable.
• Remedy: • Check that TOMAS is correctly connected ËPage 32 • Replace TOMAS .

• Code: 11:10
• Description: Connection problem with the Trailing cable. Trailing Cable does not seem to be connected.
• Remedy: • Check that the Trailing Cable is not damaged. • Check that the Trailing Cable is correctly connected to the Carriage PCA, Interconnect PCA and to the Sausalito PCI PCA. • Replace the Sausalito PCI PCA . • Replace the Ink Supply Tubes and Trailing Cable . • Replace the Carriage PCA .

• Code: 14.01:00
• Description: Temperature high on the Heat sink. Over temperature in the Heatsink. At least one of the thermal switches attached to the Triac Heaters of the Heaters Control assembly has reached 90c.
• Remedy: • If the ambient environmental temperature is extremely warm and the Heaters Control Assembly cooling fan has failed, check the connection of the fan, and replace if required . • Replace the Heaters Control Assembly. • If the heater resistor value is too low, locate which of the heaters and replace: • Change the heaters in the Dryer Assembly. • Change the heaters in the Curing module 

• Code: 14.02:00
• Description: Current too high on the Dryer Assembly. Over current in Dryer assembly. The level of amps is over 18 amps, or the amount of current requested from the Dryer assembly is too high.
• Remedy: • Check if there is an AC voltage surge from the customers electricity supply. • Replace the Dryer Assembly . • If the level of AC voltage is normal, replace the Heater Control Assembly 

• Code: 14.03:00
• Description: Current too high on the Curing Module. Overcurrent in Curing Module. The level of amps is over 18 amps, or the amount of current requested from the curing Module is too high.
• Remedy: • Check if there is an AC voltage surge from the customers electrical supply. • Replace the heaters in the Curing Module, replace . • If the level of AC voltage is normal, replace the Heater Control Assembly .