• Code: 08.04
• Description: The Front Panel watchdog timer has expired
• Causes: The Front Panel watchdog timer has expired.
• Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Upgrade the firmware.

• Code: 08:04.1
• Description: ASSERT in Front Panel code
• Causes: ASSERT in Front Panel code.
• Remedy: 1. Press Enter and continue. 2. Update the firmware.

• Code: 08:08
• Description: ASSERT in Front Panel code
• Causes: ASSERT in Front Panel code.
• Remedy: Switch the power off at the rear of the printer, wait briefly, then switch it back on again.

• Code: 08:11
• Description: A Front Panel application has died
• Causes: A Front Panel application has died.
• Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Replace the Front Panel.

• Code: 11:10
• Description: Connection problem with the Trailing Cable
• Causes: The Trailing Cable does not seem to be connected.
• Remedy: 1. Check that the Trailing Cable is not damaged. 2. Check that the Trailing Cable is correctly connected to the Carriage PCA, Interconnect PCA, and Main PCA. 3. Replace the Ink Supply Tubes and Trailing Cable

• Code: 14.31:10
• Description: Pinch Power regulator V null and no fault
• Causes: Pinch Power regulator V null and no fault.
• Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Run the Monitoring Sine-waves and Resistances diagnostic test. 3. Replace the control cables to the sine-wave converter.

• Code: 14.32:01
• Description: Pinch Power regulator V null and faulty
• Causes: Pinch Power regulator V null and faulty.
• Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Run the Monitoring Sine-waves and Resistances diagnostic test. 3. Check the Residual Current Circuit Breakers. 4. Check the input voltage.

• Code: 14.33:01
• Description: Pinch Power regulator V lower than 140
• Causes: Pinch Power regulator V lower than 140.
• Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Check the input voltage. 3. Run the Monitoring Sine-waves and Resistances diagnostic test.