• Code: 02.1:10
• Description: Problem with the Carriage PCA
• Causes: The Carriage PCA has failed to respond.
• Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Check that the Trailing Cable is not damaged. 3. Check that the Trailing Cable is correctly connected to the Carriage PCA, Interconnect PCA, and Main PCA. 4. Replace the Carriage PCA.

• Code: 02:10
• Description: Mechanical Carriage error
• Causes: Mechanical Carriage error.
• Remedy: Corrective action: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Replace the Carriage Assembly.

• Code: 03.10:10
• Description: Extra 24 V PSU failure
• Causes: Extra 24 V PSU failure.
• Remedy: 1. Switch the power off at the rear of the printer. 2. Disconnect all drying fans (not the array, the fans one by one). 3. Switch the printer on. 4. If the error persists, check that Secondary PSU cables are properly connected to PrintMech PCA and Main PSU. 5. If the error persists, replace the Extra 24 V PSU. 6. Connect the fans one by one until the error returns. Use the diagnostic test for the fans; it should switch them all on. 7. Replace the drying fan that caused the error. 8. Make sure that you test all of them: more than one may be faulty.

• Code: 03:10
• Description: Power distribution failure
• Causes: The Power Supply Unit (PSU) may have failed.
• Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. If the Power Supply Unit's blue LED is on, replace the PrintMech PCA. 3. Otherwise, replace the Power Supply Unit.

• Code: 05.01:10
• Description: Formatter CPU fan stopped or burnt out
• Causes: Formatter CPU fan stopped or burnt out.
• Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Replace the Formatter.

• Code: 05:10
• Description: Formatter communication failure with ISS
• Causes: The Formatter is not communicating with the Ink Supply Station.
• Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Check that the Formatter to PrintMech PCA cable is correctly connected. 3. Replace the Formatter.

• Code: 06.03
• Description: Main NVM communication failure
• Causes: The Main NVM is not responding.
• Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Replace the Hard Disk Drive.

• Code: 06.10
• Description: Main NVM communication failure
• Causes: The Main NVM is not responding.
• Remedy: 1. Switch the power off at the rear of the printer, wait briefly, then switch it back on again. 2. Replace the Hard Disk Drive.