Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi HP Latex 360 — Trang 8/32

Code: 12.9:10

Description: Printmech: Hannibal3 24V failure. Check Inner lights array 1
Causes: The 24V cable from Printmech to Inner lights array 1 has a problem Printmech PCA is damaged.
Remedy: Call agent: • Restart the printer. Service engineer: 1. Check the Inner lights array 1. 2. Check the Printmech PCA.

Code: 13.3:10

Description: Printmech 12V_BULLI_2 to Vapor Removal PCA out of range
Causes: The Printmech 12V_BULLI_2 to Vapor Removal PCA is out of range.
Remedy: Call agent: • Restart the printer. Service engineer: 1. Check the Printmech cable to Vapor Removal PCA. 2. Check the Printmech PCA.

Code: 14.73:01

Description: Curing power regulator V lower than 60: V lower than 60
Causes: Heater Control AC Input (RCCB, AC Voltage Outlet, AC Power Cord) Heater Control.
Remedy: Call agent: 1. Check that both Residual Circuit Breakers (RCCBs) are Powered and ON. 2. Check/Reseat both Power Cords. Service engineer: 1. Check AC Voltage at customer's site (180-264Vac). 2. Reseat/Replace cables to Heater Control's AC input. 3. Replace the Heater Control.

Code: 14.74:01

Description: Curing power regulator V lower than 140
Causes: V lower than 140
Remedy: Service engineer: 1. Run Service "Curing system monitor". 2. Check the input voltage.

Code: 14.75:01

Description: Curing power regulator V bigger than Vmax
Causes: V bigger than Vmax
Remedy: 1. Check the input voltage. 2. Run Service "Curing system monitor".

Code: 14.76:11

Description: Curing power regulator V could not be read
Causes: Curing Control PCA Cable to Heater Control.
Remedy: Service engineer: 1. Run Service "Curing system monitor". 2. Reseat/Replace Curing Control PCA Cable to Heater Control.

Code: 14.77:10

Description: Curing power regulator control signal failure
Causes: Control signal failure
Remedy: Service engineer: • Replace the Control PCA to Heater Control and Control PCA cables.

Code: 14.80:10

Description: Curing power regulator current not null
Causes: Heater Control.
Remedy: Service engineer: 1. Run Service "Curing system monitor". 2. Replace the Heater Control.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie