• Code: 14.81:10
• Description: Curing power regulator current too high
• Causes: Heaters, Heater Control.
• Remedy: Service engineer: 1. Run Service "Curing system monitor". 2. Check heaters with a tester and replace heaters if necessary (shortcut). 3. Replace the Heater Control.

• Code: 14.82:10
• Description: Curing power regulator shortcut
• Causes: Heaters, Heater Control.
• Remedy: Service engineer: 1. Run Service "Curing system monitor". 2. Check heaters with a tester and replace heaters if necessary (shortcut). 3. Replace the Heater Control.

• Code: 14.83:11
• Description: Curing power regulator open circuit
• Causes: Heater Control to Curing Power Interconnect PCA Cable. Curing Power Interconnect PCA Curing Cable. Curing Resistor.
• Remedy: Service engineer: 1. Run Service "Curing system monitor". 2. Reseat/Replace the Heater Control to Curing Power Interconnect PCA Cables. 3. Reseat/Replace Curing Power Interconnect PCA Curing Cable. 4. Reseat/Replace all Curing Resistors connectors.

• Code: 14.87:10
• Description: Curing power regulator OverTemp
• Causes: Power regulator OverTemp.
• Remedy: Service engineer: 1. Run Service "Curing system monitor". 2. If the SE appears frequently, replace the Heater Control.

• Code: 14.88:10
• Description: Curing power regulator overvoltage or shortcut
• Causes: Regulator overvoltage or shortcut.
• Remedy: Service engineer: 1. Run Service "Curing system monitor". 2. Check resistor module values, If they are ok, check installation.

• Code: 14.89:10
• Description: Curing power regulator relay damaged
• Causes: Heater Control.
• Remedy: Service engineer: 1. Run Service "Curing system monitor". 2. Replace de Heater Control.

• Code: 15.20:10
• Description: Cable or Resistor shortcircuit from any PZ or vapor resistor
• Causes: Shortcircuit from Any PZ or vapor resistor.
• Remedy: Service engineer: • Check the PZ resistors, the Vapor resistors, or cable shortcircuits. Replace the affected part.

• Code: 15.31:10
• Description: PZ resistor 1: Cable or resistor shortcircuit
• Causes: Cable or resistor shortcircuit.
• Remedy: Service engineer: • Check the PZ resistor 1 or cable shortcircuit.