Code :

Code: 33.02.01
Description: Used board/disk installed Used board disk installed. An encrypted board or disk with existing data previously locked to a different product has replaced the original. If you continue, data is permanently lost.
Remedy: 1. Reinstall the used board or disk back into its original printer. 2. To save the data on the board or disk, turn the product off. Replace the board or disk with another board or disk. 3. To delete the data on the board or disk and continue, touch the OK button.

Code: 33.03.03
Description: Incompatible formatter installed. This is and EFI BIOS event to prevent booting with the wrong formatter installed.
Remedy: Power down the printer and install the correct formatter in the device. NOTE: If it is believed that the formatter is the correct part number and model for this printer, replace the formatter again and return the formatter in question to HP for evaluation.

Code: 33.03.XX
Description: • 33.03.01: Save recover engine storage ID unexpected length. • 33.03.02: Data size mismatch unable to recover DCC MVRAM.
Remedy: Power the printer off then back on. If issue is not resolved replace the ICB and return to HP for evaluation.

Code: 40.00.01
Description: USB I/O buffer overflow To continue, touch “OK” The USB buffer has overflowed.
Remedy: 1. Touch the OK button to print the transferred date (some data might be lost). 2. Check the host configuration.

Code: 40.00.02
Description: Embedded I/O buffer overflow To continue, touch “OK” The product has experienced a JetDirect buffer overflow.
Remedy: 1. Touch the OK button to print the transferred date (some data might be lost).2. Check the host configuration.

Code: 40.00.03
Description: EIO <X> buffer overflow To continue, touch “OK” Too much data was sent to the EIO card in the specified slot (x). An incorrect communications protocol might be in use.
Remedy: Touch the OK button to print the transferred date (some data might be lost).

Code: 40.00.04
Description: EIO <X> bad transmission To continue, touch “OK” The connection between the product and the USB device has been broken.
Remedy: 1. Touch the OK button to clear the error message and continue printing.2. Remove, and then reinstall the USB device.

Code: 40.00.05
Description: Embedded I/O bad transmission To continue, touch “OK” The USB device has been removed.
Remedy: 1. Touch the OK button to clear the error message (data will be lost).2. Install the USB device.