• Code: 111.61
• Description: Printhead drive control out of range due to an external event beyond what the control is designed to handle.
• Remedy: Step 1: Check the printhead unit cables JLSU1 and J6 for proper connection. Are they properly connected? Yes: Go to step 2. No: Reseat the cables.
  Step 2: Inspect the printhead cables and connectors. Are they free of damage? Yes: Replace the controller board. No: Replace the printhead.

• Code: 111.62
• Description: Closed-loop printhead error, off-resonant PI effort state.
• Remedy: Step 1: Check the printhead unit cables JLSU1 and J6 for proper connection. Are they properly connected? Yes: Go to step 2. No: Reseat the cables.
  Step 2: Inspect the printhead cables and connectors. Are they free of damage? Yes: Replace the controller board. No: Replace the printhead.

• Code: 111.63
• Description: Timed out on POR sweep.
• Remedy: Step 1: Check the printhead unit cables JLSU1 and J6 for proper connection. Are they properly connected? Yes: Go to step 2. No: Reseat the cables.
  Step 2: Inspect the printhead cables and connectors. Are they free of damage? Yes: Replace the controller board. No: Replace the printhead.

• Code: 111.64
• Description: Attempted to exceed open loop drive limits.
• Remedy: Step 1: Check the printhead unit cables JLSU1 and J6 for proper connection. Are they properly connected? Yes: Go to step 2. No: Reseat the cables.
  Step 2: Inspect the printhead cables and connectors. Are they free of damage? Yes: Replace the controller board. No: Replace the printhead.

• Code: 111.65
• Description: Attempted to exceed open loop drive limits.
• Remedy:

• Code: 111.66
• Description: Failed alignment of printhead.
• Remedy: Step 1: Check the printhead unit cables JLSU1 and J6 for proper connection. Are they properly connected? Yes: Go to step 2. No: Reseat the cables.
  Step 2: Inspect the printhead cables and connectors. Are they free of damage? Yes: Replace the controller board. No: Replace the printhead.

• Code: 111.67
• Description: Failed alignment of printhead.
• Remedy: Step 1: Check the printhead unit cables JLSU1 and J6 for proper connection. Are they properly connected? Yes: Go to step 2. No: Reseat the cables.
  Step 2: Inspect the printhead cables and connectors. Are they free of damage? Yes: Replace the controller board. No: Replace the printhead.

• Code: 111.68
• Description: Too many fake HSYNCs while aligning printhead.
• Remedy: Step 1: Check the printhead unit cables JLSU1 and J6 for proper connection. Are they properly connected? Yes: Go to step 2. No: Reseat the cables.
  Step 2: Inspect the printhead cables and connectors. Are they free of damage? Yes: Replace the controller board. No: Replace the printhead.