Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Konica-Minolta bizhub 920 pro — Trang 31/32

Code: SC80-40

Description: When the main power switch (SW1) is ON, a region into which no write was made by the ISW is detected in the FS control program.
Causes: FS control program

Code: SC80-45

Description: When the main power switch (SW1) is ON, a region into which no write was made by the ISW is detected in the IC program.
Causes: IC program

Code: SC90-01

Description: Initial communication check between the ADU drive board (ADUDB)/ printer control board (PRCB). ADU drive serial input abnormality 1. Within a specified period of time after the ACK at the time of the main power switch (SW1) being turned ON, a serial data from ID = 0 of the ADUDB is not received.
Causes: ADU drive board (ADUDB) Printer control board (PRCB) Loose connection

Code: SC90-02

Description: Communication error check between the ADU drive board (ADUDB)/ printer control board (PRCB). ADU drive serial input abnormality 1. Within a specified period of time after the ACK at the time of the main power switch (SW1) being turned ON, a serial data from ID = 7 of ADUDB is not received.
Causes: ADU drive board (ADUDB) Printer control board (PRCB) Loose connection

Code: SC93-01

Description: 12V ICP blowout in the ADU drive board (ADUDB). A -5V ICP blowout signal and blowout of a 12V ICP signal are detected for the serial initial communication.
Causes: ADU drive board (ADUDB) Printer control board (PRCB) Loose connection

Code: SC93-05

Description: 24V power source check. At the start of operation, an error detection signal (solenoid/blowout of clutch ICP) is detected, and also an error detection signal (24V cut off) is detected.
Causes: Each of the solenoids Each of the clutches DC power supply /2 (DCPS2) Loose connection Wiring harness earth fault ADU drive board (ADUDB)

Code: SC93-06

Description: At the start of operation, an error detection signal (solenoid/blowout of clutch ICP) is detected. However, an error detection signal (24V cut off) is not detected.
Causes: Each of the solenoids Each of the clutches DC power supply /2 (DCPS2) Loose connection Wiring harness earth fault ADU drive board (ADUDB)

Code: SC95-01

Description: A specified period of time after the ADU cooling fan /1 (FM10), /2 (FM11) turns on, the F10/11 signal gets into an abnormal condition. This abnormal condition still recurs a specified period of time after it is turned ON again after being turned OFF, and also an error detection signal (24V cut off) is detected.
Causes: DC power supply /2 (DCPS2) ADU drive board (ADUDB) ADU cooling fan /1 (FM10) ADU cooling fan /2 (FM11) Wiring harness earth fault Loose connection
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie