Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Lexmark C760 — Trang 5/18

Code: 136

Description: Fuser Error Fuser cam position not found
Remedy: 1 Observe the fuser drive assembly gears rotate during POR. Do the gears rotate? Go to step 2 Go to step 5 2 Do the gears stop and the fuser drive assembly gears make a loud buzzing sound? Replace the FRUs in the order shown: 1. Fuser drive card. See “Fuser drive card assembly”. 2. Fuser drive assembly. See “Fuser drive assembly”. 3. “Fuser assembly”. Go to step 3 3 Check for correct installation of the fuser control cable to J33 on the system board. Make sure the cable is properly connected. Is the cable installed correctly? Go to step 4 Install the cable correctly. 4 Remove the fuser from the printer. Measure the voltage at the DC fuser control connector on the LVPS on pin 2 and 9 on the connector. The voltage should measure approximately +5 V dc. Is the voltage correct? Replace the“Fuser assembly”. Replace the “LVPS assembly”. 5 Check for correct installation of the fuser drive motor cable to connector J29 on the system board. Is the cable installed correctly? Go to step 6 Install the cable correctly. 6 Remove the fuser fan to gain access to the motor cable. Check the correct installation of the fuser drive motor cable to connector J1 on the fuser drive motor board. Is the cable installed correctly? Replace the following FRUs in the order shown: 1. Fuser drive card. See “Fuser drive card assembly”. 2. Fuser drive assembly. See “Fuser drive assembly”. 3. System board. See “System board”. Install the cable correctly.

Code: 140

Description: Motor. DC motor accel stall - registration (staging)
Remedy: Replace the “Registration motor”. If this does not fix the problem, replace the “System board”.

Code: 141

Description: Motor DC pick motor excessive PWM - registration (staging) motor
Remedy: Replace the “Registration motor”. If this does not fix the problem, replace the “System board”.

Code: 142

Description: Motor DC pick motor, over speed - registration (staging) motor
Remedy: Replace the “Registration motor”. If this does not fix the problem, replace the “System board”.

Code: 143

Description: Motor DC pick motor, no encoder feedback - registration (staging) motor
Remedy: Replace the “Registration motor”. If this does not fix the problem, replace the “System board”.

Code: 144

Description: Motor DC motor accel stall - autocompensator motor
Remedy: Replace the “Autocompensator pick assembly”. If this does not fix the problem, replace the “System board”.

Code: 145

Description: Motor DC motor excessive PWM autocompensator motor
Remedy: Replace the “Autocompensator pick assembly”. If this does not fix the problem, replace the “System board”.

Code: 146

Description: Motor Autocompensator motor over speed, autocompensator motor
Remedy: Replace the “Autocompensator pick assembly” If this does not fix the problem, replace the “System board”.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie