Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Mimaki JV33-130 — Trang 6/8

Code: 41

Display: MOTOR ALARM Y
Description: The Y-axis motor is overloaded.
Remedy: 1. Check friction of Y-axis motor. 2. Replace the Y-axis motor with a new one. 3. Replace the regenerative resistance PCB with a new one. 4. Replace the main PCB with a new one.

Code: 42

Display: X OVER CURRENT
Description: Overcurrent in the X-axis motor was detected.
Remedy: 1. Check friction of X-axis motor. 2. Replace the X -axis motor with a new one. 3. Replace the regenerative resistance PCB with a new one. 4. Replace the main PCB with a new one.

Code: 43

Display: Y OVER CURRENT
Description: Overcurrent in the Y-axis motor was detected.
Remedy: 1. Check friction of Y-axis motor. 2. Replace the Y-axis motor with a new one. 3. Replace the regenerative resistance PCB with a new one. 4. Replace the main PCB with a new one.

Code: 45

Display: CAPPING : PARAMETER
Description: An error occurred in capping control. (Improper parameter adjusted value)
Remedy: 1. Make sure that the adjusting value of [#ADJUST] - [CAPPING] is set correctly.

Code: 46

Display: WIPER
Description: An error occurred in wiper control.
Remedy: 1. Check that the wiper sensor functions properly with [#TEST] - [SENSOR TEST]. 2. Check that the wiper motor functions properly with [#TEST] - [MOTOR TEST]. 3. Make sure that there is no friction on the guide rail caused by sticking of ink. 4. Replace the wiper sensor with a new one. 5. Replace the stepping motor with a new one. 6. Replace the station PCB with a new one.

Code: 50

Display: MEDIA DETECT
Description: Paper could not be detected. The media set position or media itself is not proper.
Remedy: 1. Make sure that there is no gap between the end faces of platen and platen rubber. 2. Execute [#TEST] -[PAPER SENSOR] to obtain sensor values at the media exist position and media non-exist position. When the difference of values is more than ±50, detection is allowed. If the difference is smaller, execute the followings. 3. Clean the paper width sensor or replace with a new one. 4. Replace the ink slider PCB with a new one.

Code: 51

Display: Y-ORIGIN
Description: Y-origin could not be detected.
Remedy: 1. Check that the Y origin sensor works properly with [#TEST] - [SENSOR TEST]. 2. Replace the Y origin sensor with a new one. 3. Replace the station PCB with a new one.

Code: 70

Display: FPGA
Description: FPGA Configuration fails.
Remedy: 1. Replace the main PCB with a new one.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie