Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi OKI C3530 MFP — Trang 5/6

Code: 190

Display: Service call 190: Error
Description: System memory overflow
Remedy: Does the error recur? Yes Turn on the power supply again. Install an additional RAM DIMM.

Code: 200, 201, 202

Display: Service call 200: Error - 202: Error
Description: PU Firmware Download Error
Remedy: Error occurs when the PU firmware is rewritten After the power supply is turned on again, try to download again. (Because this processing is not performed during usual operation, it does not occur.)

Code: 203 ... 214

Display: Service call 203: Error 204: Error 207: Error 208: Error 213: Error 214: Error F0C: Error FFE: Error FFF: Error
Description: CU program trouble (203~214 are not generated in usual operation)
Remedy: Incorrect processing is performed by the CU program. Does the error recur? Turn on the power supply again. Replace M32 board.

Code: 209

Display: Service call 209: Down Load Error
Description: Custom Media Type table download failure
Remedy: Failed in downloarding Custom Media Type Table After the power supply is turned on again, try to download again. (Because this processing is not performed during usual operation, it does not occur.)

Code: 230

Display: Service call 230: Error
Description: RFID Reader not Installed
Remedy: RFID Reader Device error. Does the error recur?
Check the connenction of the LUM board (RFIS reader/writer board). Replace the LUM board (RFID reader/writer board). Replace the M32 board.

Code: 231

Display: Service call 231: Error
Description: RFID Reader I/F Error
An interface error was detected with the RFID reader device.
01: communication error between the RFID reader and the engine PCB.
02:the transcever circuit error of the RFID reader.
03:communication error between the RFID reader and the toner cartridge.
04:the toner cartridge detection error (more than 4).
Remedy: 01: Same as Error 230. 02: Replace the LUM board (RFID reader/writer board). 03: Check the connection of the antenna cable. 04: Check if the number of toner cartridge is correct.

Code: 240

Display: Service call 240: Error
Description: Engine Program. Memory Error
240: Flash Memory Hardware Error
Remedy: If the error occurs again after returning on the power supply, replace the board of the unit.

Code: 905, 906

Display: Service call 905: Error 906: Error
Description: Short circuit error of the Frame thermistor (thermistor defect) is detected
Remedy: Does the error recur? Yes Check the cable connection between the ZAK board and M32 board and turn on the power again. Replace the fuser unit. Replace the M32 board.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie