Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi OKI C8800 — Trang 4/8

Code: 122

Display: SERVICE CALL 122:Error
Description: Low-voltage power supply fan error. Low-voltage power supply temperature error.
Remedy: Is fan in low-voltage power supply unit operating? Is fan connector connected properly?
Check connections for connector of fan. Replace low-voltage power supply. Replace fan motor. Replace low-voltage power supply.

Code: 123

Display: SERVICE CALL 123:Error
Description: Abnormal environment humidty /Not connected humidity sensor.
Remedy: Does error reoccur? Yes Power OFF/ON Replace the operator panel PCB (PRP).

Code: 124

Display: SERVICE CALL 124:Error
Description: Abnormal environment temperature.
Remedy: Does error reoccur? Yes Power OFF/ON Replace the operator panel PCB (PRN).

Code: 126

Display: SERVICE CALL 126:Error
Description: Condensation in the printer was detected.
Remedy: Condensation iss likely to occur in printers carried from the outside. Turn on the printer again after it is exposed to room temperature for two hours to half a day. Does the error reoccur? Yes Turn on the printer again after it is left alone. Replace the operator panel PCB (PRP).

Code: 127

Display: SERVICE CALL 127:Error
Description: Error detected at the fuser unit cooling fan.
Remedy: Is fan connector connected properly? Does error reoccur?
Connect properly again. Replace fan motor. Replace PU PCB.

Code: 128

Display: SERVICE CALL 128:Error
Description: Error detected at the fuser-end cooling fan.
Remedy: Is fan connector connected properly? Does error reoccur?
Connect properly again. Replace fan motor. Replace PU PCB.

Code: 131 ... 134

Display: SERVICE CALL 131:Error ~ 134:Error
Description: LED head fault detected. (131 = Y, 132 = M, 133 = C, 134 = K)
Remedy: Is LED head properly set? Is the LED head fuse blown out? Does error reoccur?
Install the LED head unit properly. Check the LED head fuse on the CU PCB. Change CU PCB. Turn on the power again. Replace the LED head unit.

Code: 142

Display: SERVICE CALL 142:Error
Description: Error detected at ID position of Up/Down(142 )
Remedy: Is ID unit set properly? Does error reoccur?
Reset ID unit. Turn power ON again. Replace ID Up/Down sensor.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie