Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi OKI C8800 — Trang 6/8

Code: 172, 173

Display: SERVICE CALL 172:Error 173:Error
Description: Abnormal temperature detected by fuser thermistor (hightemp or low temp.)
Remedy: Does error reoccur? Turn power ON again. Replace fuser unit. Replace the low-voltage power supply.

Code: 174

Display: SERVICE CALL 174:Error
Description: Short circuit in back up roller thermistor detected (at high temperature).
Remedy: Does error reoccur? Yes Turn power ON again. Replace fuser unit.

Code: 175

Display: SERVICE CALL 175:Error
Description: Open of back up roller thermistor detected (at low temperature).
Remedy: Does error reoccur? Yes Turn power ON again. Replace fuser unit.

Code: 176, 177

Display: SERVICE CALL 176:Error 177:Error
Description: Abnormal (high) temperature of back up roller thermistor detected.
Remedy: Does error reoccur? Turn power ON again. Replace fuser unit. Replace the low-voltage power supply.

Code: 181, 182

Display: SERVICE CALL 181:Error 182:Error
Description: Option unit I/F error. (181 = Duplex Unit, 182 = Option Tray)
Remedy: Does error reoccur? Yes Turn power ON again. After checking connection parts of connector, replace option unit.

Code: 190

Display: POWER OFF/ON 190:Error
Description: System Memory Overflow.
Remedy: Does error reoccur? Yes Turn power ON again. Add option RAM DIMM.

Code: 200, 201, 202

Display: SERVICE CALL 200:Error ~ 202:Error
Description: PU Firmware download Error.
Error occurered while writing over the PU firmware.
Remedy: Error occurered while writing over the PU firmware. Turn the printer OFF/ON, and retry to download the PU firmware again. (Usually, the procedure (PU firmware download) which isn’t done, so this is not occur.)

Code: 203, 204, 207, 208, 214, F0C, FFF

Display: POWER OFF/ON 203:Error
204:Error 207:Error 208:Error
214:Error F0C:Error FFF:Error
Description: An error was detected of the CU program. (203~214 is not occure in usual operating.)
Remedy: Reinstall the CU board. Is the error message displayed again? After turn power OFF, check connections between CU board and PU board. Then turn power ON again.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie