Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi OKI C8800 — Trang 7/8

Code: 209

Display: POWER OFF/ON 209:Download Error
Description: Media Table download Error.
Downloading Media Table to PU has failure. (Related to Custom Media Type)
Remedy: Downloading Media Table to PU has failure. (Related to Custom Media Type) Turn the printer OFF/ON, and retry to download the PU firmware, again. (Usually, the procedure isn’t done, so this is not occur.)

Code: 230

Display: SERVICE CALL 230:Error
Description: RFID Reader not Installed
Remedy: RFID read device error Is the error issued again? Yes Yes Check the connection of the RFID R/W board. Replace the RFID R/W board. Replace the S2V PCB.

Code: 231

Display: SERVICE CALL 231:Error
Description: RFID Reader I/F Error
An interface error was detected with the RFID reader device.
01: communication error between the RFID reader and the engine PCB.
02: the transceiver circuit error of the RFID reader.
03: communication error between the RFID reader and the toner cartridge.
04: the toner cartridge detection error(more than 4).
Remedy: 01: Same as Error 230 02: Replace RFID R/W board. 03: Check the antenna cable connection. 04: Check to see if the quantity of toner cartridge is correct.

Code: 901, 902

Display: POWER OFF/ON 901:Error 902:Error
Description: Short or open in belt thermistor detected.
Remedy: Is belt thermistor cable setting proper? Does error reoccur?
Connect cable set properly again. Turn power ON again. Replace belt thermistor.

Code: 903, 904

Display: POWER OFF/ON 903:Error 904:Error
Description: Abnormal temperature detected by belt thermistor (hightemp or low temp.)
Remedy: Is belt thermistor cable setting proper? Does error reoccur?
Connect cable set properly again. Turn power ON again. Replace belt thermistor and leave aside for 30 min. Then turn power ON again.

Code: 918

Display: POWER OFF/ON 918:Error
Description: Duplex FANO Alarm Detection
Remedy: FAN error inside the Duplex. Is the error issued again when the power is turned on again?
Check to see if the Duplex is properly installed. Check to see if the FAN is properly connected. Replace the FAN.

Code: 923

Display: POWER OFF/ON 923:Error
Description: Black Image Drum Lock Error
Remedy: The black image drum (K-ID) does not rotate properly. Is the error message issued again when the power is turned on?
Check to see if the K-ID is properly installed. Replace the K-ID. Replace the K-ID motor.

Code: 928

Display: POWER OFF/ON 928:Error
Description: Fuser MotorLock Error
Remedy: The fuser unit does not rotate properly. Does the error reoccur after power cycling?
Check to see if the fuser unit is properly installed. Replace the fuser unit. Replace the fuser motor.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie