Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi OKI pro510DW Printer — Trang 7/11

Code: 190

Display: Service Call 190: Error
Description: System Memory Overflow
Remedy: System Memory Overflow Power OFF/ON. Replace CUPCB. Replace EEPROM

Code: 200 ... 202

Display: Service Call 200: Error to 202: Error
Description: PU Firm Download Error
Remedy: Error occurred when downloading PU firmware. After turning ON the power again, try downloading again. (This process isn’t executed for regular operations, therefore, will not occur)

Code: 204 ... 213

Display: Service Call 203: Error 204: Error 207: Error to 213: Error Power Off/on nnn: p 0xFOC: Error 0xFOD:Error 0xFFE:Error 0xFFF:Error
Description: CU Program Dysfunction
Remedy: Detected illegal process with CU program. Yes Write down the 24 digit number displayed on the LCD panel and report it. Turn OFF the power. Then check the insertion of the CU board. Now turn ON the power again.

Code: 209

Display: Power On/off209: DOWNLOAD ERROR
Description: Custom Media Table Download Error
Remedy: Failed to download custom media table. After turning ON the power again, try downloading again. (This process isn’t executed for regular operations, therefore, will not occur)

Code: 220

Display: Service Call 220: Error
Description: Print Statistic mismatch
Remedy: HDD was removed or replaced after print statistic is set to ON. Get the original HDD back.

Code: 230

Display: Service Call 230: Error
Description: RFID Reader not Installed
Remedy: 1) RFID read device error Yes Check the connection of the RFID R/W board. 2) Does the Error take place again? Yes Replace the RFID R/W board. Replace the S2X board.

Code: 231

Display: Service Call 231: Error
Description: RFID Reader I/F Error
Remedy: An interface error was detected with the RFID reader device. 01: communication error between the RFID reader and the engine PCB. 02: the transceiver circuit error of the RFID reader. 03: communication error between the RFID reader and the Toner cartridge. 04: the Toner cartridge detection error (more than 4). 01: Same action as for error 230 02: Replace the RFID R/W board. 03: Check the connection of the antenna cable. 04: Check to confirm that the number of Toner cartridge is correct.

Code: 240, 241, 247

Display: Service Call 240: Error 241: Error 247: Error
Description: Engine Program Memory Error
Remedy: 240:Flash-memory hardware error 241 :Duplex flashmemory error 247:Sub-CPU flashmemory error If the error still occurs after rebooting, replace the circuit board of the relevant unit.
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie