Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 2022 — Trang 6/17

Code: 510

Description: LCT lower limit error
The lower limit sensor does not activate within 8 seconds after the tray has been lowered.
Causes: • Tray lift motor defective • Poor connection of the tray lift motor • Lower limit sensor defective • Too much load on the drive mechanism

Code: 520

Description: Paper tray error
An error occurs (i.e motor error, or sensor error, etc) for any paper tray.
Causes: • A defective motor • A defective sensor • Too much load on the drive mechanism

Code: 541

Description: Fusing thermistor open
The fusing temperature detected by the thermistor was below 0 °C for 5 seconds. The fusing temperature does not rise +15 °C (center) or +12 °C (at the ends) five times within 2 minutes after the fusing lamps have been turned on.
Causes: • Fusing thermistor defective or out of position • Fusing lamp open • Fusing thermostat open • Power supply board defective • Poor connection of the fusing unit

Code: 542

Description: Fusing temperature warm-up error
The fusing temperature does not reach the standby temperature within 20 seconds after the main switch is turned on.
Causes: • Fusing thermistor defective or out of position • Fusing lamp open • Fusing thermostat open • Power supply board defective • Poor connection of the fusing unit

Code: 543

Description: Fusing overheat error 1
A fusing temperature of over 231°C is detected for 5 second by the fusing thermistor.
Causes: • Fusing thermistor defective • Power supply board defective • SBCU board defective

Code: 544

Description: Fusing overheat error 2
A fusing temperature of over 251°C is detected by the fusing temperature monitor circuit in the SBCU board.
Causes: • Fusing thermistor defective • Power supply board defective • SBCU board defective

Code: 545

Description: Fusing overheat error 3
After warmup, the hot roller attained full operating temperature and maintained this temperature for 10 sec. without the hot roller rotating.
Causes: • Hot roller thermistor is out of position • Fusing lamp broken • Thermostat broken

Code: 546

Description: Unstable fusing temperature
The fusing temperature varies 50°C or more within 1 second twice continuously.
Causes: • Thermistor defective • Poor connection of the fusing unit • Power supply unit defective
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie