Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 3228C

Code: 101

Description: Exposure lamp error
The standard white level is not properly detected when scanning the shading plate. (The shading data peak does not reach the specified threshold.)
Causes: • Exposure lamp defective • Lamp stabilizer defective • Exposure lamp connector defective • Standard white plate dirty • Scanner mirror or scanner lens out of position or dirty • SBU defective

Code: 120

Description: Scanner home position error 1
• The scanner home position sensor does not detect the "off" condition during scanning. • The scanner home position sensor does not detect the "off" condition during initialization.
Causes: • Scanner I/O board or SBU defective • Scanner motor defective • Harness between scanner I/O board and scanner motor disconnected • Scanner HP sensor defective • Harness between SBU and HP sensor disconnected • Scanner wire, timing belt, pulley, or carriage defective

Code: 121

Description: Scanner home position error 2
• The scanner home position sensor does not detect the "on" condition during initialization. • The scanner home position sensor does not detect the "on" condition when starting to scan. • The scanner home position sensor does not detect the "on" condition when the scanner returns.
Causes: • Scanner I/O board or SBU defective • Scanner motor defective • Harness between scanner I/O board and scanner motor disconnected • Scanner HP sensor defective • Harness between SBU and HP sensor disconnected • Scanner wire, timing belt, pulley, or carriage defective

Code: 142

Description: White level detection error
The white level cannot be adjusted within the target during auto gain control.
Causes: • Dirty exposure glass or optics section • SBU board defective • BICU board defective • Exposure lamp defective • Lamp stabilizer defective

Code: 144

Description: SBU communication error
The operation software version for the SBU does not match the installed SBU.
Causes: • Update the BICU software. • Replace the SBU.

Code: 161

Description: IPU error
The self-diagnostic error for the IPU occurs immediately after the main power is turned on.
Causes: • IPU board defective • BICU board defective (defective connection between ASICs)

Code: 195

Description: Serial number mismatch
Serial number stored in the memory is not correct.
Causes: • NVRAM defective • BICU replaced without original NVRAM

Code: 199

Description: PSU fan error
The PSU fan low signal is detected for 2 seconds when the PSU fan controller sends the high signal to the PSU fan.
Causes: • PSU fan defective • Disconnected or damaged harness
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie