Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 3228C — Trang 7/17

Code: 552

Description: Warm-up time over (pressure roller)
The main switch is turned on or a cover is closed. The fusing pressure roller does not reach the ready temperature within 200 seconds.
Causes: • Defective lamp (loose connection, thermostat failure, PSU, thermostat) • Incorrect detection (thermistor loose connection, fusing - drawer loose connection)

Code: 553

Description: Overheat error (pressure roller)
The pressure roller thermistor detects 165°C for 5 seconds.
Causes: • Loose connection • Defective BICU board • Defective PSU

Code: 554

Description: Low temperature error (pressure roller)
During standby or operation, the pressure roller thermistor detects 60°C or less for 5 seconds.
Causes: • Defective lamp (loose connection, thermostat failure, PSU, thermostat) • Incorrect detection (thermistor loose connection, fusing - drawer loose connection)

Code: 555

Description: Full power error (pressure roller)
Fusing unit warm-up is complete. The fusing pressure roller stops turning. The pressure roller lamp keeps outputting the maximum power for 150 seconds.
Causes: • Thermistor loose connection • Fusing - drawer loose connection

Code: 556

Description: Unstable temperature (pressure roller)
The pressure roller thermistor detects unstable temperature increases or decreases within 60 seconds.
Causes: • Thermistor loose connection • Fusing - drawer loose connection

Code: 557

Description: Zero cross over error
The main switch is turned on; the fusing relay turns on. The detected zero cross is out of the target range (less than 45 or more than 65). The zero cross is detected more than 65 in ten cases out of eleven zero cross detections.
Causes: • Noise from a power supply line

Code: 570

Description: Fusing oil end
500 sheets of paper have been output since oil end was detected.
Causes: • Insufficient oil (the oil tank in the rear of the machine) • Defective oil pipe • Defective oil pump • Defective oil end sensor

Code: 571

Description: Fusing oil overflow
• The oil overflow sensor detects oil. • When the machine covers are closed, the oil supply unit is not detected. • When the machine covers are closed, the fusing unit is not detected.
Causes: • Defective oil end sensor • Defective oil overflow sensor • Defective sensor cable • Oil supply unit not installed
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie