Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio 3228C — Trang 5/17

Code: 480

Description: ID sensor error
The ID sensor is being calibrated (process control, step 1) While the LED is off, the output voltage is 0.5 V or lower.
Causes: • Defective ID sensor • Defective circuit • Defective connector

Code: 481

Description: Transfer belt mark detection error
• The main motor is operating or changes its speed. The lock signal is detected. The belt mark sensor signal is not detected for 0.2 second in normal speed mode or 0.4 second in half speed mode.
Causes: • Defective main motor • Image transfer belt out of position • Belt mark blurred or absent

Code: 503

Description: 3rd tray error
• The tray lift motor turns on. The top of the paper stack is not detected for 18 seconds. • The tray is set. The top of the paper stack is detected. The bottom plate is lowered. The stack detection is not cleared within 7 seconds. These steps are repeated 4 times.
Causes: • Defective paper height sensor • Defective tray lift motor

Code: 504

Description: 4th tray error
• The tray lift motor turns on. The top of the paper stack is not detected for 18 seconds. • The tray is set. The top of the paper stack is detected. The bottom plate is lowered. The stack detection is not cleared within 7 seconds. These steps are repeated 4 times.
Causes: • Defective paper height sensor • Defective tray lift motor

Code: 515

Description: Duplex unit communication error
• A connection error occurs. • The signal is sent from the copier to the duplex unit every 3 seconds while paper is not transported by the unit. However, the duplex unit does not respond within 5 seconds.
Causes: • Defective duplex unit board • Defective BICU • Defective IOB • Defective connection (Main unit - Duplex unit)

Code: 520

Description: Fusing unit motor
• The motor starts or changes speed. The lock signal does not continue for 1 second within a 3second interval. • The motor starts. The lock signal is detected and operation proceeds normally. The lock signal is interrupted for 1 second.
Causes: • Defective fusing unit motor

Code: 521

Description: Paper feed motor error
• The motor starts or changes speed. The lock signal does not continue for 1 second within a 3second interval. • The motor starts. The lock signal is detected and operation proceeds normally. The lock signal is interrupted for 1 second.
Causes: • Defective paper feed motor

Code: 530

Description: Fusing fan motor error
• The main power is turned on. The fusing fan lock signal is detected for 2 seconds. • The fusing fan is activated. The fusing fan lock signal is not detected for 2 seconds.
Causes: • Defective fusing fan • Disconnected or broken harness of the fusing fan
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie