Description: AC bias charge adjustment error 2: M
An average value of 8 ms/cycle could not be attained for Vpp (AC charge bias) within 15 attempts. -or- The output of the AC charge boosted Vpp over 2.8 kV.
Causes: • Charge roller dirty • Charge roller defective • Bias terminal connection at the PCU receptacle is dirty or defective
Description: AC bias charge adjustment error 3: C
An average value of 8 ms/cycle could not be attained for Vpp (AC charge bias) within 15 attempts. -or- The output of the AC charge boosted Vpp over 2.8 kV.
Causes: • Charge roller dirty • Charge roller defective • Bias terminal connection at the PCU receptacle is dirty or defective
Description: AC bias charge adjustment error 4: Y
An average value of 8 ms/cycle could not be attained for Vpp (AC charge bias) within 15 attempts. -or- The output of the AC charge boosted Vpp over 2.8 kV.
Causes: • Charge roller dirty • Charge roller defective • Bias terminal connection at the PCU receptacle is dirty or defective
Description: Development power pack error 1: K
An interrupt checks the status of the each power pack every 2 ms. This SC is issued if the BCU detects a short in the development DC charge for black, magenta, cyan, or yellow (or V = 0) for 500 ms (250 times).
Causes: • Development power pack defective • High voltage power supply defective • High voltage power supply harness defective • Development unit defective • IOB harness disconnected or defective • IOB defective
Description: Development power pack error 2: M
An interrupt checks the status of the each power pack every 2 ms. This SC is issued if the BCU detects a short in the development DC charge for black, magenta, cyan, or yellow (or V = 0) for 500 ms (250 times).
Causes: • Development power pack defective • High voltage power supply defective • High voltage power supply harness defective • Development unit defective • IOB harness disconnected or defective • IOB defective
Description: Development power pack error 3: C
An interrupt checks the status of the each power pack every 2 ms. This SC is issued if the BCU detects a short in the development DC charge for black, magenta, cyan, or yellow (or V = 0) for 500 ms (250 times).
Causes: • Development power pack defective • High voltage power supply defective • High voltage power supply harness defective • Development unit defective • IOB harness disconnected or defective • IOB defective
Description: Development power pack error 4: Y
An interrupt checks the status of the each power pack every 2 ms. This SC is issued if the BCU detects a short in the development DC charge for black, magenta, cyan, or yellow (or V = 0) for 500 ms (250 times).
Causes: • Development power pack defective • High voltage power supply defective • High voltage power supply harness defective • Development unit defective • IOB harness disconnected or defective • IOB defective
Description: Development motor error 1: K
The PLL lock signal remained HIGH or LOW for longer than the prescribed time for the development motor of the affected color.
Causes: • Development motor shaft locked, blocked by and obstruction • DRB (Drive Board) defective
Nhận ưu đãi sớm nhất khi chương trình diễn ra
Đăng ký nhận bản tin
Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này.
Chính sách cookie
Những cookie này là cần thiết để trang web hoạt động đúng cách.
Những cookie này giúp chúng tôi hiểu cách khách truy cập tương tác với trang web.
Những cookie này được sử dụng để cung cấp quảng cáo cá nhân hóa.