Description: Laser synchronization error The main scan synchronization detector board cannot detect the laser synchronization signal for more than 5 consecutive 100 ms intervals.
Causes: • Poor connection between the laser unit and the BICU board • Damaged cable between BICU and laser unit • Laser unit • BICU board
Causes: • Dirt on the ID sensor • ID sensor not installed at the correct angle. • Defective ID sensor • Defective PCU • Development roller is not rotating
Description: ID sensor : Vsg measurement error (In-process) (D158/D159) When the ID sensor detects that Vsg is 5 V and LED drive current is minimum (PWM=0).
Causes: • Defective ID sensor • Disconnection of the harness to the ID sensor • Bad electrical contact of the ID sensor connector • Defective BCU • Defective laser unit • Defective developer density • Defective high-voltage power pack • Dirty ID sensor
Description: ID sensor : Auto adjustment value error (In-process) (D158/D159) When the ID sensor is adjusting Vsg automatically.
Causes: • Defective ID sensor • Disconnection of the harness to the ID sensor • Bad electrical contact of the ID sensor connector • Defective BCU • Defective laser unit • Defective developer density • Defective high-voltage power pack • Dirty ID sensor
Description: ID sensor : Auto adjustment time-out (In-process) (D158/D159) When the ID sensor is adjusting Vsg automatically.
Causes: • Defective ID sensor • Disconnection of the harness to the ID sensor • Bad electrical contact of the ID sensor connector • Defective BCU • Defective laser unit • Defective developer density • Defective high-voltage power pack • Dirty ID sensor
Description: P sensor error (D158/D159) SC350-354 happen during normal operation. This error isn't displayed on the panel but is left in the error log.
Causes: • Defective ID sensor • Disconnection of the harness to the ID sensor • Bad electrical contact of the ID sensor connector • Defective BCU • Defective laser unit • Defective developer density • Defective high-voltage power pack • Dirty ID sensor