Description: ID sensor adjustment timeout error Error occurred during automatic adjustment of Vsg. Vsg could not be adjusted to 4.0V ±0.2V within the prescribed time.
Causes: • ID sensor dirty or defective • ID sensor harness disconnected, or connector damaged • BCU defective • High voltage power supply board (power pack) defective
Description: ID sensor error For more details about the cause of the problem, please refer to SC350 to 354 above.
Causes: • ID sensor dirty or defective • ID sensor harness disconnected, or connector damaged • BCU defective • High voltage power supply board (power pack) defective
Description: TD sensor error 1 TD sensor output was less than 0.5V, or more than 0.5V 10 times in succession. If the fax unit is installed, this SC is issued immediately. If the fax unit is not installed, this SC is issued after the prescribed number of copies has printed.
Causes: • TD sensor abnormal • Poor connection of the PCU
Description: TD sensor error 2 The TD sensor outputs less than 0.5V or more than 4.0V 10 times consecutively during copying. Note: If the fax option is installed, this SC is issued immediately. If the fax option is not installed, this SC is issued after the prescribed number of pages is copied.
Causes: • TD sensor abnormal • Poor connection of the PCU
Description: TD sensor initial setting error Initialization of the new PCU unit failed (the drum and development roller did not start rotating).
Causes: • The PCU toner seal was not removed • ID sensor harness loose, broken • TD sensor harness loose, broken • ID sensor defective • TD sensor defective