Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP3350 — Trang 13/17

Code: 854

Description: Wireless LAN board error 2
The board that holds the wireless LAN board can be accessed, but the wireless LAN board (802.11b/Bluetooth) itself cannot be accessed while the machine is operating
Causes: • Wireless LAN board has been removed during machine operation.

Code: 855

Description: Wireless LAN board error 3
An error was detected for the wireless LAN board (802.11b or Bluetooth).
Causes: • Wireless LAN board defective • Wireless board connection not tight

Code: 856

Description: Wireless LAN board error
An error is detected for the wireless LAN board (802.11b or Bluetooth).
Causes: • Wireless LAN board defective • PCI connector loose

Code: 857

Description: USB I/F Error
The USB driver is unstable and generated an error. The USB I/F cannot be used. The USB driver can generate three types of errors: RX, CRC, and STALL errors. Only the STALL error can generate this SC code.
Causes: • USB 2.0 disconnected • Controller board defective

Code: 858

Description: Data encryption conversion error
A serious error occurred during data encryption.
Causes: 0 A Key acquisition error • Replace the controller board 1 A HDD key setting error • Turn the machine power off/on • If the error reoccurs, replace the controller board 2 A NVRAM read/write error • Replace the NVRAM 30 A NVRAM error • Turn the machine power off/on • If the error reoccurs, replace the controller board 31 A • See SC991

Code: 859

Description: HDD data encryption error
Encryption of data on the hard disk failed.
Causes: 8 B HDD check error • Format the HDD 6 B Power loss during encryption • Format the HDD 10 B Data read/write error • See SC863 below

Code: 860

Description: HDD error 1
The hard disk connection is not detected because it is defective or has not been formatted
Causes: • Cable between HDC and HDD loose or defective • HDD power connector loose or defective • HDD not formatted • HDD defective • Replace the controller board

Code: 861

Description: HDD error 2
The HDD did not enter the ready status within 30 sec. after power on.
Causes: • Cable between HDC and HDD loose or defective • HDD power connector loose or defective • HDD defective • Replace the controller board
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie