Thương hiệu phân phối chính hãng
Giỏ hàng

Mã lỗi Ricoh Aficio MP3550B — Trang 3/17

Code: 220

Description: Laser synchronization detection error: LD0
The laser synchronizing detection signal for the start position of the LD was not output for two sec. after LDB unit turned on with the polygon motor rotating normally.
Causes: • Laser synchronizing detection board harness loose or broken. • Laser synchronization detection board defective • LDB unit defective • IPU defective

Code: 230

Description: FGATE ON error
The FGATE signal did not assert within the prescribed time. (The BCU generates the FGATE signal and sends it to the LD unit when the registration sensor switches on.)
Causes: • BCU, Controller board harness loose or broken • BCU defective • Controller board defective

Code: 231

Description: FGATE OFF error
The FGATE signal did not go off within the prescribed time. (The BCU generates the FGATE signal and sends it to the LD unit when the registration sensor switches on.)
Causes: • BCU, Controller board harness loose or broken • BCU defective • Controller board defective

Code: 240

Description: LD error
The IPU detected a problem at the LD unit.
Causes: • LD unit harness broken, defective • BCU harness broken defective • LD unit defective • BCU defective

Code: 302

Description: Charge level output error
The PWM output level was detected higher than 50% after 10 consecutive samplings.
Causes: • HVPS (High Voltage Power Supply) board harness loose, broken. • PCU connection loose or broken

Code: 350

Description: ID sensor calibration – Error 1
One of the following conditions occurred when the ID sensor pattern was calibrated during printing: Vsp > 2.5V Vsg < 2.5V Vsp = 0V Vsg = 0V
Causes: • ID sensor defective or dirty • ID sensor harness disconnected or connector is damaged • BCU defective • Scanning system or image creation system malfunction • High voltage power supply board (power pack) defective

Code: 351

Description: ID sensor calibration – Error 2
The following conditions occurred simultaneously when the ID sensor pattern was calibrated during printing: Vsg = 5V PWM = 0 (LED current drop)
Causes: • ID sensor dirty or defective • ID sensor harness disconnected, or connector damaged • BCU board defective High voltage power supply board (power pack) defective

Code: 353

Description: ID sensor LED current error
Error occurred during automatic adjustment of Vsg:
• Vsg output did not attain 4V, even with PWM = 1023 (maximum current for LED) • Vsg output was greater than 4V, even with PWM=1 (no current for the LED)
Causes: • ID sensor dirty or defective • ID sensor harness disconnected, or connector damaged • IOB defective • High voltage power supply board (power pack) defective • Scanning system or image creation system malfunction
Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin Đăng ký nhận bản tin
Đăng ký nhận bản tin
Nhận ưu đãi sớm nhất khi chương trình diễn ra

Đăng ký nhận bản tin

Việc cho phép sử dụng cookie sẽ giúp cải thiện trải nghiệm của bạn trên trang web này. Chính sách cookie